NOSHOK 1800-0 User manual

User Manual
NOSHOK
ATTACHABLE
LOOP-POWERED
INDICATOR
Model 1800-0
CORPORATE HEADQUARTERS
1010 West Bagley Road
Berea, Ohio 44017
440.243.0888
440.243.3472 Fax
E-mail: [email protected]
Web: www.noshok.com
UM1800-03

A down
B program steps
C up
1. Set the decimal point
1 x B:
C/A up or down:
2. Set the lower end of the range
2 x B:
C/A up or down:
3. Set the upper end of the range
3 x B:
C/A up or down:
4. To enable error codes
4 x B:
1 x C: on
1 x A: off
C/A up or down
Errors are shown as F1 for an underrange condition,
and F2 for an overrange condition
5. Set digital filtering value
5 x B:
1 x C: 0.2 seconds
2 x C: 0.5 seconds
3 x C: 1.0 seconds
4 x C: 1.5 seconds
C/A up or down
6. Return to measurement mode
2 x A
FILT
To install, remove the DIN
43650A plug and insert the
model 1800-0 indicator on
top of transducer and reinstall
the plug. This
indicator is
designed for use
with NOSHOK
transmitters with
2-wire 4 mA to 20 mA output
and Hirschmann DIN 43650A
connector.
A B C
To program, first remove the cover from the
indicator housing and identify the buttons A, B,
and C. These buttons are used to program the
indicator to match the pressure range of the
transmitter.
d P
A n 4
A n 2 0
L1
0
1
2
3
1
0