Novah EL75ALB User manual

1
www.novah.co.uk
Atlas LED Low Bay Luminaire Manual
Version 1.1
This manual only applies to the products listed.
Contents
Introduction
1
Safety Warnings
1
Dimensions
2
Product Accessories
2
Specifications
2
Installation
2/3
Maintenance
3
Safety Warnings:
1. Upon opening the box, if it is found to be defective or damaged, please contact your
retailer as soon as possible. Do not attempt to use a damaged product
2. The product should be installed and maintained by a qualified electrician. Novah will not
take responsibility of any damages or issues that occur due to mishandling, such as
operations prohibited in this manual
3. Ensure the fixing surface is flat and even and can withstand the weight of the product.
Use adequate fittings with regards to the type of surface
4. Always isolate the mains supply before fitting or servicing. Make sure there is a correct
connection and no short circuit before powering on
5. Make sure there is no extra force or stress on the aluminium heatsink to avoid defects or
deformation
6. Please note these luminaires get very hot. Leave to stand for 10-20 minutes after use
before handling.
Introduction:
Thank you for choosing our Atlas low bay. We recommend that you read this manual carefully
before installation or usage of your product.
Please ensure you completely understand the instructions to ensure normal working of your
LED luminaire.
Low Bay: EL75ALB, EL100ALB, EL150ALB

2
www.novah.co.uk
Product Dimensions
Product Specifications
Installation
1. Ensure there are no visible faults or defects with the product before installation.
2. As shown below, there is only 1 mounting option. Please follow the appropriate
instructions.
Suspended:
Please use appropriate cables/chains supplied to suspend from the ceiling.
It is always recommended that a secondary safety cable is used for additional support
should the main one fail.
Product Code
A
B
C
EL75ALB
270
68.59
453
EL100ALB
309
67.09
453
EL150ALB
309
67.09
553
Atlas low bay
Input Voltage
100-240Vac (50/60Hz)
System Power
75w/100w/150w
Power Factor
>0.95
Luminous Flux
150lm/w
Colour Temperature
5000K
Colour Rendering Index
>80
Beam Angle
120°
IP Rating
IP54
Impact Rating
IK10
Net Weight
1.93kg, 2.5kg, 2.83kg
Operating Temp.
-20 - 40°C
A
C
B
Product Accessories
1x Atlas
2x Suspension cables
1x Instruction manual

3
www.novah.co.uk
3. Connect the fitting to the mains supply as per the following:
1. Shut off all mains electric connected to the circuit you are working on.
2. Locate the power cable on the rear of the fitting with the stripped Live, Earth and
Neutral wires.
3. Using a 15A connector block wire the power cable to the main electric feed.
4. Switch the circuit on at the breaker.
Note: You may need to change your breaker type to compensate for the higher inrush
current. Consult your electrician for more details.
4. Maintenance
It is recommended that the luminaires are cleaned at least once per year (depending on the
environment).
Mains Power
Cord