Novatel ANT-C2GA-TW-N User manual

ANT-C2GA-TW-N Antenna
The ANT-C2GA-TW-N is an active
antenna designed to operate at
the GPS L1 and L2 frequencies,
1575.42 and 1227.60 MHz. This
guide provides the basic informa-
tion you need to install and begin
using your new antenna.
ADDITIONAL EQUIPMENT
REQUIRED
The equipment listed below is required to set up the ANT-C2GA-
TW-N:
• A mount, such as a range pole, tribrach, or tripod, with a
5/8" x 11 thread
• Coaxial cable with a male TNC connector
• A device with an antenna input port that both receives
the RF signal and provides 2.5 - 24.0 VDC to the
antenna (All NovAtel GPS receivers provide the neces-
sary power through their antenna RF connectors.)
SITE SELECTION GUIDELINES
Before installing the antenna, select a site that as closely as
possible meets the following conditions for optimal performance:
• An unobstructed line-of-sight from horizon to horizon
and at all bearings and elevation angles
• As far as possible from reflective objects, especially
those that are above the antenna and any water bodies,
which can be a strong source of multipath reflections
• If obstructions and reflective surfaces are within 30 m,
ensure the site is as high as possible. Otherwise, mount
the antenna as low as possible.
• For base station locations, ensure the antenna is in a
low-multipath location, close to the ground and away
from reflective objects.
INSTALLING THE ANTENNA
Both the input DC power and the output RF signal flow over a
single coaxial cable that is connected to the unit's TNC female
connector.
The antenna baseplate features an internal thread that accepts a
5/8” x 11 threaded bolt. This allows the antenna to be used on a
tripod.
Caution: Overtightening a bolt into the base may damage the base.
After a site has been selected, install the antenna as follows.
1. Verify that the thread on the mount does not extend more
than 1/2" (12 mm) to ensure the thread is not damaged
when the mount is inserted. If it extends further than 1/2" (12
mm), add two jam nuts to shorten the exposed thread,
ensuring the nuts are well-tightened.
2. Align the mount thread with the internal thread on the bottom
of the antenna and rotate the antenna clockwise until it is
securely screwed to the mount.
Ref. # Description
1 Radome
2 Internally threaded
3 TNC connector
4 Thread
5 Jam nuts or flange
6 Mount
3. Remove the dust cap from the antenna’s TNC connector.
4. Attach the male TNC connector of the coaxial cable to the
antenna’s TNC connector.
Ref. # Description
1 TNC connector
2 Coaxial cable
5. Attach the other end of the coaxial cable to the antenna input
port of the receiving device, which must provide power as
detailed in the SPECIFICATIONS section of this guide. All
NovAtel GPS receivers provide the necessary power
through their antenna RF connectors.
ANTENNA CARE
The ANT-C2GA-TW-N is designed to withstand the elements,
including rain, snow, and dust. However, to ensure your antenna
performs optimally, keep the radome clean and brush off any ice
and snow. In addition, ensure the TNC connector remains clean
and dry and replace the dust cap when a cable is not connected.
L1 ELEVATION GAIN PATTERN
L2 ELEVATION GAIN PATTERN
USER GUIDE
5/8 x 11"3/8 - 1/2 9 - 12 mm""( )
1
23
4
56
1
2
dB
dB

SPECIFICATIONS MECHANICAL DRAWINGS
PHASE CENTER
Please refer to the Mechanical Drawings before reading this
section.
Height = Vertical phase center offset from antenna reference
point or antenna reference plane (ARP), see the
MECHANICAL DRAWINGS section of this guide.
For relative offset numbers and phase center variation (PCV)
tables, please visit the U.S. National Geodetic Survey (NGS)
website at www.ngs.noaa.gov/ANTCAL/.
For absolute offset numbers and to download PCV tables,
please visit the GEO++ website at www.geopp.com.
When using either of the websites mentioned above, look for the
NovAtel listing of your antenna model and its hardware revision.
At the time of print, we are unable to provide typical absolute and
relative offset numbers for the current ANT-C2GA-TW-N
antenna model. Please check our website for updates to this
manual at www.novatel.com/Downloads/docupdates.html and
the websites mentioned above.
If you need any further advice on this matter, please visit our
website at www.novatel.com. Other methods of contacting
Customer Service can be found on the last panel of this guide.
WEEE NOTICE
If you purchased your ANT-C2GA-TW-N in Europe, please return it to
your dealer or supplier at the end of its life. The objectives of the EU's
environment policy, in particular, are to preserve, protect and improve
the quality of the environment, protect human health and utilise natural
resources prudently and rationally. Sustainable development advocates
the reduction of wasteful consumption of natural resources and the
prevention of pollution. Waste electrical and electronic equipment
(WEEE) is a regulated area. Where the generation of waste cannot be
avoided, it should be reused or recovered for its material or energy.
WEEE products may be recognised by their wheeled bin label.
WARRANTY POLICY
NovAtel Inc. warrants that its Global Positioning System (GPS) products are free from
defects in materials and workmanship, subject to the conditions set forth below, for the
following periods of time:
GPSAntenna™ Modules: One (1) Year
Cables and Accessories: Ninety (90) Days
Date of sale shall mean the date of the invoice to the original customer for the product.
NovAtel's responsibility respecting this warranty is limited solely to product repair at an
authorized NovAtel location only. Determination of repair will be made by NovAtel personnel
or by technical personnel expressly authorized by NovAtel for this purpose.
The foregoing warranties do not extend to
(i) nonconformities, defects or errors in the products due to accident, abuse, misuse or negli-
gent use of the products or use in other than a normal and customary manner, environmental
conditions not conforming to NovAtel’s specifications, or failure to follow prescribed installa-
tion, operating and maintenance procedures, (ii) defects, errors or nonconformities in the
products due to modifications, alterations, additions or changes not made in accordance with
NovAtel’s specifications or authorized by NovAtel, (iii) normal wear and tear, (iv) damage
cause by force of nature or act of any third person, (v) shipping damage; or (vi)service or
repair of product by the dealer without prior written consent from NovAtel.
In addition, the foregoing warranties shall not apply to products designated by NovAtel as
beta site test samples, experimental, developmental, preproduction, sample, incomplete or
out of specification products or to returned products if the original identification marks have
been removed or altered.
The warranties and remedies are exclusive and all other warranties, express or implied,
written or oral, including the implied warranties of merchantability or fitness for any particular
purpose are excluded.
NovAtel shall not be liable for any loss, damage or expense arising directly or indirectly out of
the purchase, installation, operation, use or licensing or products or services. In no event
shall NovAtel be liable for special, indirect, incidental or consequential damages of any kind
or nature due to any cause.
There are no user-serviceable parts in the GPSAntenna and no maintenance is required. If
the unit is faulty, replace with another unit and return the faulty unit to NovAtel Inc. You must
obtain a RETURN MATERIAL AUTHORIZATION (RMA) number by calling NovAtel
Customer Service at 1-800-NOVATEL (U.S. and Canada only) or 403-295-4900 before ship-
ping any product to NovAtel or a dealer. Once you have obtained an RMA number, you will
be advised of proper shipping procedures to return any defective product. When returning
any product to NovAtel, please return the defective product in the original packaging to avoid
damage.
Before shipping any material to NovAtel or Dealer, please obtain a Return Material
Authorization (RMA) number from the point of purchase. You may also visit our website
(http://www.novatel.com) and select Support | Repair Request from the side menu.
QUESTIONS OR COMMENTS
If you have any questions or comments regarding your antenna, please contact NovAtel
Customer Service using one of methods provided below.
Email: [email protected]
Web: www.novatel.com
Phone: 1-800-NOVATEL (U.S. & Canada)
403-295-4900 (International)
Fax: [phone]
© Copyright 2002-2009 NovAtel Inc. All rights reserved.Printed in Canada on recycled paper.
Unpublished rights reserved under international copyright laws. Recyclable.
OM-20000085 Rev 3 April 20, 2009
RF
3 dB pass band (typical) L1: 1575.42 ±13 MHz
L2: 1227.60 ±13 MHz
Out-of-band rejection (typical) > 40 dBc
Gain at zenith (θ = 90°) (min) L1: +7.7 dBic L2: +4.7 dBic
Gain roll-off (zenith to horizon) L1: 15.2 dB L2: 18 dB
L1/L2 LNA gain (typical) 31/33 ±2 dB
Polarization Right-hand circular
Noise figure (typical) 3.0 dB
Nominal impedance 50 Ω
VSWR ≤ 1.5 : 1
POWER
Input voltage 2.5 - 24.0 VDC
Current (typical) 35 mA
PHYSICAL
Diameter 308 mm (12.12")
Weight 4.1 kg (9.1 lb.)
ENVIRONMENTAL
Maximum altitude 9000 m (29527.5 ft)
Operating temperature -55°C to +85°C (-67°F to +185°F)
Storage temperature -55°C to +85°C (-67°F to +185°F)
Design standards
D0-160D
DO228
MIL-C-5541
MIL-E-5400
MIL-I-45208A
MIL-STD-810
SO-C144
SAE J1455
TNC Fe m a le C onne c t or
(SMA o r N Type is optional)
1750 [44.45]
He lix Coil:
THD 0.625-11UNC-2Bx0.72”Deep
ΦΦ 12.120 [ 307.85]
Phase Center: x= y= 0,
z= 2.0 [50.80] from bottom
for both L1 and L2
8.774 [222.85]
2.846 [72.30]
= HEIGHT
ARP
Dimensions are in inches
followed by [mm]
5”