novocare FlexPen Operating instructions

PATIENT FACT SHEET - HOW TO USE FLEXPEN®
For direct distribution by Healthcare Professionals to users prescribed Novo Nordisk devices only.
Needle Paper tab
Outer
needle cap
Inner
needle cap
NovoFine®Needles
Outer
needle cap
Inner
needle cap Needle Paper tab
4mm 32G
4mm 32G 6mm 32G Tip 8mm 30G
6mm & 8mm
Attaching a NovoFine®needlePreparing for injection
Remove paper tab from a
NovoFine
®
needle. Attach
needle on to FlexPen
®
so that it is straight and
secure.
Pull off the outer needle
cap. Keep it to remove
the needle from the pen
after injection.
Pull off the inner needle
cap and dispose of it.
Check the label to make
sure that your FlexPen
®
contains the correct type
of insulin.
Pull off the pen cap.
If you are using a cloudy
insulin mix it before use
(instructions overleaf).
Turn the dose selector to
2 units.
Hold your FlexPen®with
the NovoFine
®
needle
pointing upwards. Tap
the cartridge gently with
your finger a few times
to make any air bubbles
collect at the top of the
cartridge.
Keep the NovoFine®
needle upwards and press
the push-button all the
way in. The dose selector
should return to 0.
A drop of insulin should
appear at the needle
tip. If not, change the
NovoFine
®
needle and
repeat the procedure
no more than 6 times.
If a drop still does not
appear, you must use a
new FlexPen®.
Turn the dose selector to
select the number of units
you need to inject. The
dose can be corrected by
turning the dose selector
in either direction until the
correct dose lines up with
the white pointer.
Note: When turning the
dose selector, be careful
not to push the push-
button as insulin will
come out.
Push the needle into the
skin, then press the dose
button until you feel or
hear a click and the dose
indicator lines up with 0.
Only push the push-
button when injecting
and not before.
Keep the push-button
fully pushed in after the
injection.
Leave the needle under
the skin for 6 seconds
and then remove it.
To remove the NovoFine®
needle simply guide the
needle into the outer
needle cap.
When the needle is
covered, carefully push
the outer needle cap
completely on and
unscrew the needle.
Dispose of the NovoFine®
needle carefully into a
sharps container and put
the pen cap back on.
Checking the insulin flow (Priming)
Priming (Cont.) Setting the dose Administering the injection
1
6
2
7
3
8
4
9
5
10
2 units selected
Six seconds
• FlexPen®is designed for use with NovoFine®needles.
• Pen image shown is for solution
insulin.
• Suspension (cloudy) insulin
contains a glass ball inside the
cartridge.
Pointer
Pen cap Cartridge
Residual
scale
Dose
selector
Push-
button
FlexPen®
NEW

PATIENT FACT SHEET - HOW TO USE FLEXPEN®
Function Check
1 Screw on a new NovoFine®needle.
2 Prime FlexPen®.
3 Dial 20 units and put the big outer
needle cap onto the NovoFine®needle.
4 Dispense 20 units into the needle
cap holding the pen with the needle
pointing downwards.
5 The solution will fill the lower part of
the cap.
Maintenance
• Your FlexPen®is designed to work with NovoFine®needles.
• Your FlexPen®is designed to work accurately and safely.
It must be handled with care.
• If it is dropped or crushed, there is a risk of damage and
leakage of insulin.
•Do not soak, wash or lubricate it as this may damage the pen.
• Do not refill your FlexPen®.
• Do not share your FlexPen®with anyone else.
• Always remove the NovoFine®needle after each injection and
store FlexPen®without the needle attached.
Patients registered with the National Diabetes Services Scheme
(NDSS) are entitled to 1,200 needles every 180 day period free
of charge with or without scripts, from NDSS pharmacies and
Diabetes Australia.
20 Units
Roll the pen
between your
palms 10 times –
it is important that
the pen is kept
horizontal.
Move the pen up and down 10 times between
the 2 positions as shown (this should move the
glass ball from one end to the other). Continue
rolling and moving until the liquid appears white
and cloudy (resuspended).
Note : Always check there are at least 12 units of
insulin left in the cartridge to allow resuspension.
If there are fewer than 12 units left, use a new
NovoMix®30 FlexPen®.
When using NovoMix®30 F l exPen®
Let the insulin reach room temperature before you use it. This makes it easier to resuspend.
Use the injection technique shown to
you by your Healthcare Professional.
Always
use a new
NovoFine®
needle every time you inject
Remember
NovoCare®Customer Care Centre
1800 668 626 www.novonordisk.com.au
NEW
4mm 32G 6mm 32G Tip 8mm 30G
Please see your Healthcare Professional for any further information
about your diabetes treatment.
This sheet is intended as a quick guide only and does not replace FlexPen
®
user manual or the CMI enclosed in your prescribed insulin pack. FlexPen
®
user manual can be
found inside every new pack of FlexPen
®
. The CMI and user manual should be read carefully before use. For distribution by Healthcare Professionals.
Novo Nordisk Pharmaceuticals Pty Ltd. ABN 40 002 879 996. Level 3, 21 Solent Circuit, Baulkham Hills, NSW 2153. ® Registered trademark of Novo Nordisk A/S.
McK32749. 01/14.
PATIENT FACT SHEET - HOW TO USE FLEXPEN®
For direct distribution by Healthcare Professionals to users prescribed Novo Nordisk devices only.