NRS Healthcare S09347 User manual

1
USER INSTRUCTIONS
ADJUSTABLE BATH-STEP RANGE
S09347 1 x Nuvo Bath Step, 2 x NRS Bath Steps & Pillars
General Safety Warning
Please make sure that you read and follow these
instructions carefully. Keep these instructions in
a safe place for future reference.
Maximum User Weight
50st
317kg
1. INTENDED USE
The NUVO Adjustable Bath-Step has been designed to assist users transferring into and out of the bath
by reducing the step-over height. It can also provide assistance when using the toilet or sink in a bathroom
environment.
2. SAFETY
WARNING: The maximum user weight must not be
more than 317Kg (50st).
WARNING: The maximum step height is 175mm
(7”) using 6 step sections (2 packs).
DO NOT: Stack more than 6 step sections together.
ALWAYS: Make sure the bottom section of the step
has 4 support pillars inserted into the base.
ALWAYS: Make sure the overmoulded section is
placed on the top.
3. UNPACKING
Remove the packaging and check all parts carefully.
Contact your supplier immediately if parts are
missing or damaged and do not try and assemble.
3.1 Contents:
1. Overmould Step 50mm (2”) x 1
2. Step 50mm (2”) x 2
3. Support Pillar x 4
4. ASSEMBLY/INSTALLATION
4.1 Single Step - 50mm (2”) Step Height:
Use the single overmoulded step section.
1. Turn the overmoulded step section upside down
and lay flat.
2. Push the four support pillars into position (see
Figure 1).
Figure 1: Insert Support Pillars
3. Turn the step over to stand on the pillars and
place in the desired location.
4.2 Two Steps - 75mm (3”) Step Height:
1. Push the four support pillars into position on
one of the non-overmoulded step sections (see
Figure 1).
2. Place the overmoulded step section on top of
the first.
3. Push down firmly to secure.
4.3 Three Steps - 100mm (4”) Step Height:
1. Place a third step section inbetween the bottom
section and the overmoulded top section.
2. Push down firmly to secure.

2
4.4 For a Step Sequence:
This set-up provides a series of 2 steps, the first at
50mm (2”), the second at 75mm (3”).
Note: An additional overmoulded step section and
support pillars are required to achieve this set up.
See Section 7.0 for details.
1. Turn one overmoulded section and one non-
overmoulded sections upside down and lay flat.
These will become the base steps.
2. Push the 8 x support pillars into position, four on
each step section (see Figure 1).
3. Turn the base steps over to stand on the pillars.
4. Link the two sections together by overlapping
the cut out section on one with the protruding lip
on the other.
5. Push down firmly to secure.
6. Place the second overmoulded step section on
top of one of the non-overmoulded base section.
7. Push down firmly to secure.
Note: To achieve a similar set up with greater height
or more steps in the sequence, additional packs of
steps and support pillars must be purchased. See
Section 7.0 for details.
Note: The safe maximum step height is 175mm (7”).
This uses 2 packs, 6 step sections. Do not stack
more than 6 sections together.
5. MAINTENANCE
Check that all support pillars are inserted correctly
and any additional sections are securely fitted.
Inspect the product regularly for signs of wear or
damage. Any suspected faults or damage should
immediately be reported to the supplier and the
product taken out of use.
6. CLEANING INSTRUCTIONS.
Clean regularly using a general purpose, neutral
detergent and warm water.
Please check the suitability of the cleaning products
before use. Do not use abrasive cleaners or cloths
as these could permanently damage the surface and
invalidate any warranty.
To disinfect, wipe with a dilute bleach solution and
rinse thoroughly with fresh water.
This product can be autoclaved on cycles up to 80°C.
Allow the product to dry fully prior to use/storage.
7. ACCESSORIES & SPARE PARTS
S20677: NUVO Overmoulded Step Section and
Support Pillars x 4
M11077: Non-overmoulded Step Sections x 3 and
Support Pillars x 4
M24345: Support Pillars x 4
For more details please visit our website or call
Customer Services on the details below.
8. PRODUCT DISPOSAL
This product must be thoroughly cleaned/sterilised
prior to disposal.
This product is manufactured from plastic and can
be disposed of through Local Authority Household
Waste and Recycling Centres or through Local
Trade Waste Collectors.
9. PRODUCT GUARANTEE
NRS Healthcare guarantee this product for a period
of 12 months, from the date of purchase, against
faulty materials and workmanship.
This guarantee does not cover; abuse, misuse,
interference or tampering with any part of the product.
Any guarantee issued by NRS Healthcare does not
affect your statutory rights.
S09347-UI-1 01-09-2022
NRS HEALTHCARE Sherwood House, Cartwright Way, Forest Business Park
Bardon Hill, Coalville, Leicestershire, LE67 1UB, UK.
Tel: Customer Services: 0345 121 8111 Email: [email protected]
NRS Healthcare is a leading supplier of community equipment and daily living aids.
Please visit one of our websites to view our full range of products:
www.healthcarepro.co.uk or www.completecareshop.co.uk