CareCo BA07059 Programming manual

Smart Toilet Seat Lifter - BA07059
www.careco.co.uk CareCo, Hubert Road, Brentwood, Essex, CM14 4JE
Usage and Maintenance Instructions
The Smart Toilet Seat Lifter is a clever bathroom mobility aid designed to help you open and close the
toilet seat with just your feet. Attach the Smart Toilet Seat Lifter to your toilet by following the steps
below.
1. Connect the arms
Take the two connectors and feed them
through the eyes of the arm case and the
arm extension. Connect the arm extension
to the seat bracket and the arm case to
the pedal.
2. Fasten the arm
Fasten the plastic arm extension to the
arm case with the nuts and bolts provided.
Arm Extension
You should have these parts:
Arm Case x1
Arm Extension x1
Pedal x1
Base x1
Long
Screws
x2
Short
Screws
x4
Seat
Bracket
x1
Connectors
x2
Non-slip
Pads x6
Nuts x2
Bolts x2
Smart Toilet Seat Lifter - BA07059
Usage and Maintenance Instructions
www.careco.co.uk CareCo, Hubert Road, Brentwood, Essex, CM14 4JE
Instructions
Arm Case

3. Install non-slip pads
Optional: Place the non-slip pads on the
bottom of the pedal and the bottom of the
base, as shown in the diagram.
4. Connect the pedal and the base
Line the pedal up with the joint of the base
and press firmly to snap into place.
5. Attach to toilet seat
Attach the seat bracket 5 inches from the
back of the toilet seat using the four small
screws provided. Optional: Use 1/8th inch
drill bit to drill pilot holes in the toilet seat
for the screws.
6. Your Smart Toilet Seat Lifter is ready to use!
Set your new Smart Toilet Seat Lifter next to
your toilet and adjust the arm to the correct
height.
Smart Toilet Seat Lifter - BA07059
Usage and Maintenance Instructions
www.careco.co.uk CareCo, Hubert Road, Brentwood, Essex, CM14 4JE