NTI E-BEEP2-x Instruction Manual

1
E-BEEP2-x
Miniature Piezo Buzzer, PCB Mount, 85dB
Guide for Installation with an ENVIROMUX
Enterprise Environment Monitoring System
E-BEEP2-x is a general purpose piezo buzzer to provide audible indication of alert when configured to respond to variations in a
sensor’s readings. Operating on 12VDC, the E-BEEP2-x can be controlled and powered by an E-2D, E-5D or E-16D Enterprise
Environment Monitoring System (SYSTEM). With an optional 12VDC power supply, the E-BEEP2 can also be controlled by an
E-MINI-LXO. A 22AWG 2-wire cable (x) is pre-soldered to the leads and available in lengths of
1/10/50/100/200/400/600/800/1000 feet.
Follow the wiring diagrams below to connect the E-BEEP2-x to a SYSTEM and then configure the SYSTEM to power the piezo as
part of an alert response to provide users with audible indication of alert. An example of that configuration can be found on page
2.

2
Figure 1- Sensor configuration page from E-16D
Figure 2- Sensor configuration page from E-2D
For the
E
-16D, on sensor
configuration page, place a checkmark
in the “Enable Siren” box for any
sensor that should activate the piezo
when it causes the ENVIROMUX to
send an alert.
For the
E
-2D,
E
-5D, or E-MINI-LXO, on
sensor configuration page, make sure
the associated output relay isn’t “none”
and either change the “Output Relay
status on alert” to Active (if connected
as shown in the drawing) or Inactive
(if you connect the piezo wire to the
N.C. relay terminal).

3
Specifications
Mounting PCB Mount- 7.62 mm centers (without pre-attached leads)
Operating Mode Continuous sound at 4KHz
Operating Voltage 1-18 Vdc
Typical Operating Current 20 mA at 12 Vdc
Typical Sound Pressure @ 10cm 85 dB(A)
Termination Solder terminals (long lead is positive)- 2-wire cable pre-attached (white
wire is positive)
Operating Temperature -20 ~ 60˚C
Storage Temperature -20 ~ 60˚C
Available 2-Wire cable lengths 1/10/50/100/200/400/600/800/1000 feet.
Dimensions (WxH) 0.61x0.55 in (15.5x14 mm)
WARRANTY INFORMATION
The warranty period on this product (parts and labor) is two (2) years from the date of purchase. Please contact Network
Technologies Inc at [phone] (800-RGB-TECH) or [phone] or visit our website at http://www.networktechinc.com for
information regarding repairs and/or returns. A return authorization number is required for all repairs/returns.
MAN204 Rev. 2/6/20