NTI ENVIROMUX-SRN-MTR-xxxV Series User manual

ENVIROMUX-SRN-MTR-xxxV
with ENVIROMUX-RLY-SRNMTR
150dB Motor Siren with Relay Kit
Installation Instruction
The ENVIROMUX-SRN-MTR-xxxV Motor Siren (xxx = 110 or 220) is used to deter intruders and alert personnel of alert conditions
when used in conjunction with an ENVIROMUX-SEMS-16, ENVIROMUX-SEMS-16U or ENVIROMUX-2D/-5D/-16D Server
Environment Monitoring System (SYSTEM). It requires the ENVIROMUX-RLY-SRNMTR relay kit to connect the siren to a SYSTEM
(as shown below). Once connected, the SYSTEM can be configured to activate the 150dB siren as needed to alert personnel.
Installation
1. Mount the ENVIROMUX-SRN-MTR where desired.
2. Mount the electrical enclosure provided close enough to the siren to connect the cable from the siren.
3. Connect the ENVIROMUX-SRN-MTR-xxxV and ENVIROMUX-RLY-SRNMTR to a SYSTEM and connect a power source as
shown in the diagrams below.
NETWORK
TECHNOLOGIES
INCORPORATED
Tel:[phone]
Fax:[phone]
1275 Danner Dr
Aurora, OH 44202
www.networktechinc.com
NTI R
ENVIROMUX®Series
The Relay Kit includes a relay circuit
board mounted inside an electrical
enclosure. (Cover plate not shown)
Note: All wiring should be done by a
certified, licensed electrician.

4. Configure the SYSTEM to power the siren as part of an alert response to provide users with audible indication of alert. An example
of that configuration can be found below.
Figure 1- Sensor configuration page from ENVIROMUX-16D
For the ENVIROMUX-16D, on sensor
configuration page, place a checkmark
in the “Enable Siren” box for any
sensor that should activate the siren
when it causes the ENVIROMUX to
send an alert.

Figure 2- Sensor configuration page from ENVIROMUX-2D
Specifications:
•Connections: screw terminal
•Output level: Max. 150 dB
•Input Voltage: 120VAC (Siren) / 12VDC (Relay PCB)
•IP44 rated protection
•Dimensions WxDxH: 4.58x5.7x6.5in (115x145x165 mm)
•Weight: 6.5 lbs
Warranty Information
The warranty period on this product (parts and labor) is two (2) years from the date of purchase. Please contact Network
Technologies Inc at [phone] (800-RGB-TECH) or [phone] or visit our website at http://www.networktechinc.com for
information regarding repairs and/or returns. A return authorization number is required for all repairs/returns.
COPYRIGHT
Copyright © 2012,2013 by Network Technologies Inc. All rights reserved. No part of this publication may be reproduced, stored in a
retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without
the prior written consent of Network Technologies Inc, 1275 Danner Drive, Aurora, Ohio 44202.
CHANGES
The material in this guide is for information only and is subject to change without notice. Network Technologies Inc reserves the right
to make changes in the product design without reservation and without notification to its users.
Man183 Rev 6/20/13
For the ENVIROMUX-2D, 5D, or
ENVIROMUX-MINI-LXO, on sensor
configuration page, make sure the
associated output relay isn’t “none”
and either change the “Output Relay
status on alert” to Active (if connected
as shown in the drawing) or Inactive
(if you connect the siren wire to the
N.C. relay terminal).