NUBAND-I NU-G0018 User manual

Model: NU-G0018
www.nutechdesign.com
NUBAND-i APP

- 1 -
FCC Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.

- 2 -
COMPATIBILITY
QUICK START GUIDE
The Nuband-i smart wristband only supports the following selected mobile devices:
iOS version (iOS 8.0 upwards):iPhone 5 onwards, iPod touch 5th Gen onwards,
iPad mini 2 onwards, iPad Air onward
Android Phones (Android 4.4 upwards): Samsung Galaxy S4 onwards, Samsung Note 3 onwards
or other smartphone
Time: 00:00 Steps : Distance:
Calories: Alarm clock: Sleep monitor:
Move Alert: Call ID Display: Message notification:
Bluetooth: Remote camera controller：Bluetooth broadcast:
Phone Finding:
1. You should charge your Nuband for 1-2 hours prior to use. Remove module as diagram shown
below and plug into USB charge socket in either a computer or a USB plug.

- 3 -
QUICK START GUIDE
2.Install free APP: Go to App store or play store, download this APP: “Nuband i” and install it. To
use Nuband i APP, make sure your mobile device connected with internet via Wi-Fi or 3G/4G.
3.Account set-up: Open the “Nuband i” App. Setting your personal information to start.
4.Bracelet Operation Instruction.
You can use the bracelet by “wrist gesture” or “touch screen”.
It is convenient to check the time by “wrist gesture”.
You need to turn on “Palming gestures” on the Nuband-i App under setting screen.
Keep the bracelet screen horizontally. Then turn wrist over. The bracelet will be turned on
automatically and the time shows up.

- 4 -
“Toucch Screen”
PS: Function may be changed and upgraded according to the bracelet firmware’s update.
5.Pairing.
Keep your phone with Bluetooth and WIFI “on” for this step. Keep the screen lit and your
nuband- i will show an icon of a radar.
Function
Starting-up
Hold finger on the screen.
0000 a code will then apper.This is your Nuband-i code
Note and use when binding device
Touch the screen or turn the wrist over
Swipe left and right
Touch the screen
Hold finger on the screen
Swipe left and right to the interface then swipe up or down swith to
Long press the screen to turn off the device
Light up the screen
Shutdown
Switch function
Flip-Over
Confirm
Operation

- 5-
Login the App Nuband i, and the
system shows the main page. Tap
the left corner button or slide the
screen from left to right, and click【
Device Connection】
Double click the screen of the
Nuband ,the radar icon “ ”shows up
on the screen ,Tap the button【
Searching device】on APP,select
your right ID from the device list, and
wait for 1-2 seconds
Metric

If the pairing pop-up does not appear within 1 minute, repeat the above steps. There would be
a Bluetooth icon instead of the Radar icon
- 6-
Android device will pop
up【Confirm pair with “right
ID”】, and it will be connected.
IOSdevice will pop up【Pair
Device Success】,【Bluetooth
Pairing Request】, click ”pair”,
and finish pairing.

6.SYNC Data
The bracelet will SYNC data automatically after being connected with phone by APP(Nuband i),
the bracelet time will be calibrated to the same time as the phone. SYNC data includes: steps,
calorie, distance. You can check out if the data SYNC is completed successfully on the APP. First
SYNC data takes 1-2 minutes. SYNC data can be done manually by clicking the refresh button on
APP.
If unable to sync, disconnect Bluetooth and start process again until successful.
7.Sleep monitor
Turn on Sleep Mode：Slide to the moon icon , hold finger on screen until icon shows and
bands buzzes, then it will pop up and show time along with the moon icon, , This
means sleep mode is now active.
Exit the sleep mode：press the screen to light up display, hold finger on screen until till it
shakes, then the moon icon will disappear. Now display is back to the original that shows time ,
this means that awake mode is now active.
8.Auto sleeping mode
Turn on the sleeping-mode by setting, , the band will check if you
are in sleeping-mode during 8:00p.m.-9:00a.m.
9.Searching for mobile phone
Hold finger on the searching for phone icon until in shakes, the searching mobile will
ring if it is under ringing mode, will shakes one time if it under vibration mode.
10.Sedentary reminder
Open the Sedentary reminder and settle the time quantum
by the Sedentary reminder setting. The time settling should be a valid time quantum, like
9:00-17:00 instead of 9:00-5:00, then it under Sedentary reminder mode successfully.
The band will shake and show sedentary icon if kept motionless for an hour.
- 7 -

11. Alarm clock
Add alarm by the Alarm setting , when it comes to the programmed
time, ，the band will shake to as a reminder and show alarm icon .
12.Camera remote controller
, Camera remote
Open the camera by APP , the band will show camera icon
controller realized by long pressing the icon.
13.Calling and message reminder
Check the push reminders and open all the notification items, for Android. Illustrated below in
(13-1), when you are going to open the Message Notify.
If it is unable to get notifications when the band is connected with mobile phone, disconnect the
Nuband from your mobile phone and shut down the notification function, then re-open it up.
(This is available in Android Apps only)
- 8-
(13-1)

(14-1) (14-2) (14-3)
(14-4) (14-5) (14-6)
14.OTA Upgrade
Attention: the phone screen must be kept lit when using this function and band connected, the
APK, APP can’t be hidden in the backstage.
When a new bracelets firmware is uploaded to the server, there will be an upgrade reminder in
APP, APK, take the following steps:(14-1 to 14-6)
- 9 -

Wait for a moment during time:
Two situations will exist while updating:
Situation 1:
At this time, when the progress
bar reaches 100% , it will
display “the upgrade is
complete”. Now hold your finger
on the screen to switch on.
Now reconnect the bracelet and
enter the firmware upgrade
again, when there shows
“Already Newest Ver.” Your
upgrade is complete!
- 10 -

Situation 2:
Wait for a moment, there may be a chance for this situation:
At this time, upgrade again. If there is no response, reconnect the bracelet and repeat the
upgrade steps! When the situation 1 occurs your upgrade will be complete!
- 11 -

- 12 -
Nuband-i + 12 month Warranty
Nuband prides ourselves in the quality of our products but every now and then there may be a
bump in the road. We therefore guarantee our products for 12 months (1 year) against defects in
materials and workmanshipunder normal use.
If a hardware defect occurs within the warranty period of 12 months Nuband will either re-
place defective part or provide a replacement product, providing proof of purchase is sent
with the item.
A replacement product or part assumes the remaining warranty of the original product or 12
months from the date of replacement or repair, whichever is longer.
When a product is exchanged or part of product is exchanged, any replacement becomes your
property and replaced item becomes Nuband’s property.
Parts provided by Nuband in fulfilment of tis warranty obligation must be used in products for
which warrantyservices is claimed.
When returning product under warranty, item must be returned along with original packaging and
retailer receipt. Without the receipt, the warrantywill be considered invalid.
It is your responsibility to back any data up. If in repair or replacement, goal data is lost Nuband
claim no responsibility for this.
Nuband is not responsible for product failure caused by none compliance with product instructions.
The warranty does not cover the cost of returning the product, this must be born by the customer.
No Nuband reseller, agent or employee is authorized to make any modification, extension or
addition to this limited warranty. If any term is held to be illegal, or unenforceable, the legality or
enforceability of the remaining terms shall not be affected or impaired.

- 13 -
iPhone®, iPod®, iPad®, iPad Mini®, iPad Air®, iOS®, Retina display®,
Apple and the Apple logo are trademarks of Apple Inc., registered in the U.S. and other countries.
App Store is a service mark of Apple Inc.
Android and Google Play are trademarks of Google Inc.
Samsung Galaxy S® and Samsung Galaxy Note® are trademarks of Samsung in the United States and other countries.
All other trademarks are property of their respective owners.
+ Product Disclaimer
Nuband is a device developed to assist monitoring aspects of your health but should never replace
the professional advice of your Doctor or Physician.
Nuband are not a licensed medical conditions or any kind, or determining the effect of any specific
exercise on a medical condition.
We strongly recommend that you should consult a Doctor or Physician before partaking in any type
of physical exercise fitness plan or diet.
Returns
Because of possible loss, we recommend insuring your Nuband, return receipt requested, when
using the mail. If you do not obtain the proper receipt within a reasonable time, start a tracer
through the originating post office. Please allow 2 to 3 weeks from the date we receive your
package for your replacement Nuband to arrive.
2016 (UK) V1
If your Nuband should ever need to be replaced under warranty, send an $8.00 check or
money order payable to AJLE 4 LLC to cover costs of postage, and handling. Please send it to
the following address:
AJLE 4LLC
ATTN: Customer Service
PO Box 2077
Cedar Park, TX 78630
USA
E-mail: [e-mail]
Nuband-i