NP08disassembly instruction
1) Master speaker
主箱维修
Remove the screws on rear panel, take out PCB, disconnect the wires, check if
there is any damage of the electronic components. Replace damaged
components if needed.
If the driver is failure, please open the front panel, take off the screws fastened the
driver and replace it.
取出螺丝 1，拔 出 PCB7 上的各种接插线，测试 PCB 上电子元件是否损坏，如果损坏
请更换元器件，如果是喇叭损坏请打开主箱前板 15，取出螺丝，更换喇叭。
2) Slave speaker
副箱维修
Remove the screws on rear panel, take out PCB, disconnect the wires, check the
components, replace the damaged components.
If the driver is failure, please open the front panel, take off the screws fastened the
driver and replace it.
取出螺丝 1，拔出 PCB18 上的接插线，测试 PCB 上电子元件是否损坏，
如果损坏请更换元器件，如果是喇叭损坏请打开主箱前板 20，取出螺丝，更换
喇叭。
