Nurseryworks Aerial Crib Conversion Kit User manual

AERIAL CRIB CONVERSION KIT
Instrucon Manual
revised 10NOV2011
Congratulations!
You are now the owner of a Nurseryworks
product...a line of modern baby furniture that
redefines the nursery. Nurseryworks’ products
are designed with both style and functionality
in mind, and we hope it becomes a source of
pleasure for you and your family. Quality material,
workmanship and pride have gone into these
products. Proper assembly is important to
ensure a safe and comfortable end result for
your baby. Please read all instructions before
assembly, and keep instructions for future use.

ENTRAPMENT/
STRANGULATION HAZARD
1
WARNING
!
•Infants have died in toddler beds from entrapment
and strangulation.
• NEVER use bed with children under 15 months.
• Guardrails must be used to avoid the formation
of a gap between the mattress and the bed that
could cause an entrapment.
• Do not suspend strings over a toddler bed for
any reason.
• For toddler bed: The minimum age shall not be
less than 15 months and the maximum weight
shall not be greater than 50lb (22.7 kg).

x1
Screw
(25mm/1”)
Screw
(35mm/1.4”)
Wrench
Metal Plate
Washer
Conversion Kit
Aerial Crib Conversion Kit
Hardware and Parts List
Be sure you follow the instructions in the order that they appear.
To avoid possible scratching, assemble furniture on a soft surface.
For instance on a carpet or blanket.
Be aware that you can use both ends of the Allen wrench.
For instance, use it lengthwise to get into tighter corners.
Be careful not to over tighten screws.
2
G x 4
H x 5
F x 8
D x 1
E x 5
Please note that screw F requires a Phillips Head Screw driver which is not provided.

Unscrew screw Awith wrench Dand take out the
mattress board and one of crib slate panel .
A
C
Installation of Conversion Kit
3

Installation of Conversion Kit
4
E
H
Insert screw Eand washer Hfrom the inside of the
mattress board to connect the conversion kit .

Installation of Conversion Kit
5
Identify the correct metal plates which are on the
crib ends by standing in front of the Crib. Then
unscrew four original metal plates.

Installation of Conversion Kit
6
Identify the four metal plates G.
Insert two of screw F into metal plate G, through
the corresponding holes as drawing illustrates.
G
F

Installation of Conversion Kit
Then place the mattress board with the conversion kit on
top of bracket C, matching up the pre-drilled screw holes.
Insert screw A (existing screw on the mattress support board)
into the hole, connecting the bracket C and tighten screws A
with wrench D, this should be done on all four brackets.
7
A