OBaby Whitby Cot Bed User manual

Designed in the UK
IMPORTANT
KEEP FOR FUTURE REFERENCE
Instructions
Cot Bed
Whitby
Version: R2-0-1

Safety Warnings Safety Warnings
Thank you for choosing Obaby. This cot bed conforms to BS EN 716-1:2017 and BS 8509 :2008
+ A1:2011. To ensure that your cot bed is used in accordance with these instructions, please read
them fully.
Your child’s safety may be affected if you do not follow these instructions.
WARNING: A child’s safety is your responsibility.
WARNING: Assembly should be carried out by a competent adult only.
WARNING: Do not use more than one mattress in the cot bed.
WARNING: Do not place this child’s bed near heat sources, windows and other furniture.
WARNING: Be aware of the risk of open re and other sources of heat, such as electric bar res,
gas res, etc. in the near vicinity of the cot bed.
WARNING: Do not use this child’s bed if any part is broken, torn or missing.
WARNING: Do not leave anything in the cot bed or place the cot bed close to another product,
which could provide a foothold or present a danger of suffocation or strangulation,
e.g. strings, blind/curtain cords etc.
• This product is intended for use from birth up to 4 years old.
• Please be aware that the lowest base position is the safest and the base should always be used in
that position as soon as the baby is old enough to sit unaided.
• The thickness of the mattress chosen should be such that the internal height (surface of the
mattress to the upper edge of the cot frame) is at least 500mm when the base is set in the lowest
position and a minimum of 200mm when the cot base is set in the highest position.
• We recommend you use the Obaby Mattress Size 140 x 70 cm for this cot bed. The mattress
should be no more then 30mm shorter or narrower than the internal length or width of the cot
bed.
• Regularly check that all ttings and components of the cot/bed are fully tightened and in working
order.
• To prevent injury from falls, as soon as the child is able to climb out of the cot then it should be
changed into the bed mode for use up until 4 years of age.
• The cot bed is designed to be dismantled for storage or transportation.
• Children are likely to play, bounce, jump and climb on beds, therefore the child’s bed should not
be placed to other furniture or windows, and should be placed either tight to the wall or have a
gap of 300mm between the wall and the side of the bed.
• All assembly ttings should be tightened properly and care should be taken to ensure that no
screws are loose, as a child could trap parts of the body, or clothing (e.g. ribbons, drawstrings,
necklaces) this could lead to strangulation.
• During assembly children should be kept away from the product due to possible risk of injury.
• Wood is a natural material, the colour will darken with age.
• Use only spare parts approved by the manufacturer.
ROUTINE CARE & MAINTENANCE
– For cleaning, use only a mild detergent and warm water.
– DO NOT USE BLEACH.
– DO NOT USE any abrasive substances.
– From time to time, check your cot for loose screws, and worn parts. Replace or adjust the parts as
needed.
Due to constant updating and improvements, some components may occasionally differ slightly
from the images shown in these instructions. We reserve the rights to change the specications of
any products without prior notice. If you need any assistance please contact your Obaby retailer
from whom you purchased your product, who will take appropriate action.
2 3
obaby.co.uk obaby.co.uk

40mm
Cot Bed Assembly 5
www.obaby.co.uk www.obaby.co.uk
40mm
Cot Bed Assembly 5
www.obaby.co.uk www.obaby.co.uk
Stage 1
Stage 2
A
A
B
C
P3
P3
P3
P3
P3
P1
P3
P1 P2
P2
P1
65mm 40mm
P2 P4P3
x12
A
A
B
B
C
Parts List Cot Bed Assembly
4 5
obaby.co.uk obaby.co.uk
Stage 1
Stage 2
A
A
B
C
P3
P3
P3
P3
P3
P1
P3
P1 P2
P2
P1
65mm 40mm
P2 P4P3
x12
A
A
B
B
C
Parts List Cot Bed Assembly
4 5
obaby.co.uk obaby.co.uk

Stage 3
B
P3
P3
P3
P3
Stage 1
B
Cot Bed Assembly Toddler Bed Assembly
WARNING: One side panel (part B) must be attached at all times in toddler bed mode
– do not use this product with both side panels removed
6 7
obaby.co.uk obaby.co.uk
Stage 3
B
P3
P3
P3
P3
Stage 1
B
Cot Bed Assembly Toddler Bed Assembly
WARNING: One side panel (part B) must be attached at all times in toddler bed mode
– do not use this product with both side panels removed
6 7
obaby.co.uk obaby.co.uk
Stage 3
B
P3
P3
P3
P3
Stage 1
B
Cot Bed Assembly
Toddler Bed Assembly
WARNING: One side panel (part B) must be attached at all times in toddler bed mode
– do not use this product with both side panels removed
6 7
obaby.co.uk obaby.co.uk

obabyuk
obaby.co.uk
obabyuk
Obaby_UK