Octane Seating Seat Connector Kit User manual

Open the fabric covering the arm and locate the threaded holes. There will be 2
on each side, for a total of 4.
Tip the seat over and locate the Velcro strip on the attached arm. Open it to
expose the inside compartment of the arm. The Seat Connector Kit will be
in a bag attached to the inside of the arm.
Seat Connector Kit Instructions
OCTANE
Seat-Connector-Kit-Instructions-v.2022-2
Scan this QR code for an
instructional video.
https://vimeo.com/696205281
Seat Connector Kit Contents
Qty (4) Wing Screws Qty (2) Right Arm Brackets Qty (2) Left Arm Brackets
- or -
Where to nd the Seat Connector Kit

Slide each of the Brackets onto the arm and line it up with the threaded holes
(there will be pre-cut slits in the cover for each bracket).
Screw the Wing Screws through the Brackets into the pre-drilled threaded holes.
Tighten by hand, no tools required.
Seat Connector Kit Instructions
OCTANE
Seat-Connector-Kit-Instructions-v.2022-2

Once the Brackets are attached, close the fabric cover using the Velcro strip. Turn the seat back upright.
Attach the seat to the chair next to it by slightly lifting it up and positioning
it into the bracket of the connecting seat.
Seat Connector Kit Instructions
OCTANE
Seat-Connector-Kit-Instructions-v.2022-2