Oeuf 1SPCR User manual

WARNING
Fall and Strangulation Hazards
DO NOT use crib until installation is complete.
Sparrow Crib Repair Kit Instructions
Model #‘s 1SPCR 2SPCR 4SPCR 5SPCR
These instructions will guide you through the steps to install the repair
kit on your Sparrow Crib. The kit is only for the recalled Sparrow
model numbers listed above. The model is on the label attached to
the mattress support.
Please read the instructions before starting. If you have questions or
need help, contact Oeuf at [phone] before you install the kit.
An instructional video is available on our website at
www.oeufnyc.com/sparrowrepairkit
OVERVIEW
The kit includes four brackets which are to be placed in the four upper
corners of the crib, where the long sides meet the short sides. The
hardware that came with your crib is used to keep the brackets in
position. It will take approximately 15-20 minutes to install the
brackets.
It is not necessary to completely disassemble crib.
PARTS Included
INSTALLATION
Completely remove screw
Completely loosen screw
Partially loosen screw (one revolution)
Fig. 1
2) Slightly pull top of long
side away from short sides
to expose the wooden
dowel. (see fig. 2)
Fig. 2
(1) Loosen screws of a long side of the
crib. (see fig. 1)
(a) Top Screw - Loosen and remove
(b) Middle Screw - Completely loosen
(c) Bottom Screw - Slightly loosen
x1
x4

(3) Position bracket between sides.
Fit wooden dowel into the bottom
hole of the bracket and line up the
top hole with the hole for the
screw. (see fig. 3)
(4) Repeat to install bracket at other end.
Push sides together and tighten all
screws. (see fig. 4)
(5) Repeat on other long side to install
remaining brackets.
Bracket
Wood dowel
Fig. 3
Fig. 4