Off the Wall Quilt Cheryl Ann's Design Walls User manual

Cheryl Ann’s Design Walls by Off the Wall Quilt
Assembly Instructions
Parts List:
1 Flannel Wall
8 Poles (sides & legs)
2 Stabilizer Bars
6 Clips
4 Corners
2 End Caps
1 Kit Bag
Step 1:
Lay the annel wall out at
Step 2:
Assemble the poles by sliding the secons together. Insert 4
poles into the hemmed edges on each of the 4 sides of the
annel wall
Step 3:
Connect poles at corners using corner pieces.
IMPORTANT:
Flannel shrinks! We recom-
mend cleaning it with a lint
brush but if washing be-
comes necessary, wash only
in cold water and immedi-
ately place the annel back
on the fully assembled
frame to dry. NEVER put the
wet annel in a dryer or
shrinkage will occur.
Prefer video instrucons?
Visit us at
www.OTheWallQuilt.com
If your clips seem to slip o the poles, try
wrapping a piece of tape around the end of
the pole

Step 4:
Place a clip on each end of a pole and snap onto the frame
(avoiding the silver connecng piece on 72” walls) in approxi-
mately the middle of a side. Rotate the wall 90 degrees and
add another cross piece. The clips may be hard to aach the
rst me, you may need to step on it gently unl it “snaps” into
place.
Step 5:
Place a clip on one end of a pole and an end cap on the oppo-
site end. Clip the pole to one side of the frame, towards an out-
side edge. Repeat with the remaining pole at the opposite
edge. These two poles are referred to as “legs”.
Step 6:
Clip a stabilizer bar to a “leg” and to the boom of the frame.
Repeat with the remaining stabilizer bar.
Need help? Call 206-618-2167
or email Info@ohewallquilt.com
Boom of wall
frame
Stabilizer Bar
Top of wall frame
Leg
Stabilizer Bar
Stabilizer Bar
Leg
Leg
Prefer video instrucons?
Visit us at
www.OTheWallQuilt.com