offi D2 POCKET DESK User manual

D2 POCKET DESK
TOOLS YOU'LL NEED
WHAT IS IN THE BOX?
1 - desk top
1 - desk drawer
1 - desk beam
4 - casters
1 - left facing leg support
1 - right facing leg support
2 - magnetic catches
2 - drawer slides (pre-attached)
PROVIDED - 1 allen key
NOT PROVIDED - 1 phillips
head screw driver
PLEASE read instructions
through before assembly!!
HELP! 1-800-958-OFFI
what is in the box?
CONTINUE ONTO THE 2ND PAGE...
1 - desk top
1 - desk drawer
1 - desk beam
1 - left facing leg support
1 - allen key
1 - right facing leg suppor
4 - casters
2 - magnetic catches
2 - drawer slides (pre-attached)
4 - magnetic
catch screws 26 - button head
screws
Love Design. Get Offi!
www.offi.com
IMPORTANT: DO NOT
TIGHTEN ANY
BUTTON
HEAD SCREWS UNTIL
ALL SCREWS ARE
LOOSELY ATTACHED
LETS GET STARTED!
1. UNPACK all components
Figure A
1. FLIP desktop upside down
2. ATTACH the 2 magnetic
catches as shown, using
the 4 magnetic catch
screws provided,
making sure the horizontal
bars on the catch are
facing the back edge of the
desk top
Figure A
Figure B
Figure B
1. LINE UP the legs as
shown - brackets facing
inwards
***NOTE that there is a left
and a right leg support,
make sure that the cut out
between the plates is
closer to the back***
2. LOOSELY ATTACH the
legs using 8 of the button
head screws and the allen
key provided - DO NOT
FULLY TIGHTEN!!

HELP! 1-800-958-OFFI
ENJOY YOUR NEW POCKET DESK!
D2 POCKET DESK
assembly instructions
D2 POCKET DESK
assembly instructions
Love Design. Get Offi!
www.offi.com
Figure C
1. SLIDE the desk beam into
place between the leg
supports
NOTE that the hinged drawer
faces the back of the legs
2. ATTACH the desk center
beam to the leg supports
using the button head
screws, 4 per side, finger
tighten each screw
3. PLACE the remaining button
head screws, attaching the
beam to the table top - finger
tighten
4. Tighten screws from Step 2
fully now, then fully tighten the
rest with the provided Allen
wrench
Figure C
Figure D
Figure E
Figure D
1. SCREW a caster into the
end of each steel leg,
making sure they are tight
and seated against the leg
bottom
Figure E
1. FLIP the desk upright, step
on the levers to lock the
casters
2. SLIDE the drawer into
position by aligning the
drawer slide track (pre-
mounted) with the matching
slide mechanism mounted to
the leg assembly
3. PUSH the drawer into the
desk to fully engage the slide
extensions, then extend the
slides fully into their locked
position
NOTE there are buttons
facing out and to the front of
the slider, push in on the
button to disengage the lock
out feature