OfficeSource PLTDEPRGREMOTE User manual

®
®www.ocesourcefurniture.com
PLTDEPRGREMOTE
ASSEMBLY INSTRUCTIONS
4-Position Memory Control
Schematic
RESET ***PERFORM RESET BEFORE 1ST USE***
Press both and buttons at the same time until both columns are in lowest position.
Display will show “000” while conducting reset.
When control box beeps, the buttons can be released and reset is complete.

®
®www.ocesourcefurniture.com
PLTDEPRGREMOTE
ASSEMBLY INSTRUCTIONS
NORMAL OPERATION
Press any button and display shows current height in centimeters (cm).
Press or button to adjust the height.
When no button has been pressed for 30 seconds, the system goes to <0.1 W standby
mode, and the display turns off. Press any button to wake the system and display the
current base height.
CHANGING STARTING HEIGHT
The default starting height is 65cm.
To adjust the starting height, press button until reaching lowest position. At the lowest
position, press button again for 5 seconds until display starts flashing for 10 seconds.
During this time, press or buttons to adjust height to preferred starting position,
and then press and buttons together for 3 seconds to store this position.
Display stops flashing and the new starting height is shown in the display.
SETTING & USING MEMORY PRESET POSITIONS
Operate the desk to preferred height.
Press any of ①②③④ together with or for 2 seconds to store the current height.
Display shows P1/P2/P3/P4 when the position has been stored.
To return table/desk to a stored position, hold the memory preset button ①②③④ until the
desk reaches the stored height.
Memory presents can be overwritten with a new position at any time. Positions are
removed, only overwritten.