Oliver TOYBOX 021317 User manual

OLIVER FURNITURE / GEPPETTO A/S
Ndr. Strandvej 119 A
DK-3150 Hellebæk / Denmark
Tel. [phone]
Fax [phone]
[e-mail]
www.oliverfurniture.dk
ASSEMBLY INSTRUCTIONS / TOYBOX 021317
PLEASE READ THE ASSEMBLY INSTRUCTION CAREFULLY BEFORE YOU START / OCT. 2007

PAGE 2
BAG OF NUTS & BOLTS
WALL BOARD REARSIDE WALL BOARD
”Receiver board”
↓
TOP STRIP
WALL STRIP
NB! 8 Felt protector pads + 2 spare
pads and 8 Porcelain knobs

PAGE 3
Mount the Wall strip with strong
screws (not incl. in the bag).
Take the height into account because
the Receiver board will grab hold of
the Wall strip when mounted.
NB! ”Receiver board” is on the back
side of the Rear Wall Board.
Insert all the Knobs; the black bolts
are inserted from the Rear side of
the Wall board.
On the upper side of the front of
the Wall board there are 2 rows of
predrilled holes. Insert the Knobs in
the upper row, as shown on the
picture to the left.
”Receiver board”
↓ ↓

PAGE 4
Insert 3 wooden nails in the Wall
board
ereafter carefully mount the Top
Strip.
Fasten the top with the long screws
from the back of the Wall Board.
When Wall board is mounted on the
Wall strip fasten the board with the
short screws.
e screws should be fasten through
the holes under the first row of
Knobs.
e Toy boxes can be mounted and
the Felt protector pads should be
placed at the back of the boxes.
↓

PAGE 5
e Side Strips on the back of the
Wall Board are not fastened at the
bottom.
If you have high floor paneling the
Strips can be cut to fit the height of
the floor panel thus ensuring that the
Wall board will fit tightly towards the
wall.
Small tip: the boxes can be stacked
when on the floor.