OMEZ LIGHTING TitanWash 108 User manual

OMEZ LIGHTING
TitanWash™ 108 Moving Head
User Instructions
OMEZ LIGHTING
11301 IRIS LN, #B
EL MONTE, CA 91731
www.omezlighting.com

TitanWash™ 108W
Moving Heads Specifications
Model: TitanWash™ 108W Moving Heads
• DMX 512 Signal, Master/Slave, Work Auto, Voice Active
• LCD Blue Display Control Panel
• 100,000 hours LED life, Energy-Saving and environment-protective;
• Dimmer channel can control 4 colors at the same time;
• Ultra-bright Leds and RGBW infinite color Mixing effects
• Beautiful blue and white liquid crystal display; Built-in 8 programs
• Auto-run or controlled by the DMX-512 Controller.
• Unit can be controlled positive and reverse direction of pan
• Low power consume
• Tilt through the DMX controller anytime
• Voltage: AC90-120V, 50/60Hz
• LED source: High power LED 3w*108pcs(R 30, G30, B30,W18)
• 25° Lens = 39.5° Beam Angle Effect
• 8,840 Lux @ 3M @ Full
• Life time: over 100,000 hours
• Beam Angle: 15/25/30/38/45 deg (optional)
• Strobe Speed: 1-25 times/second
• DMX Channels: 12 Channels
• Pan: 540deg. 16 Bit
• Tilt: 270deg. 16Bit
• Power:350W
• Condition Temperature: -18deg.-50deg.
• Size:38 x 36 x 25cm
• Net Weight:9.5KG
Titan Wash™ 108*3W Moving Heads
Photometric Beam Angle Data
25° Lens = 39.5° Beam Angle Effect
LUX
@1m LUX @ 2m LUX @ 3m
R 5489
3229 1645
G 14869
8746 3498
B 3528
2075 880
W 5293
3114 1293
Full 29178
17164 7315

Please Note: Specifications and improvements in the design of this unit and this manual are
subject to change without any prior written notice.
Unpacking: Thank you for purchasing the Titan™ 575W Moving Heads. Every
Titan™ 575W Moving Heads has been thoroughly tested and has been shipped in perfect
operating condition. Carefully check the ship-ping carton for damage that may have occurred
during shipping. If the carton appears to be damaged, carefully inspect your fixture for any
damage and be sure all accessories necessary to operate the unit has arrived intact. PLEASE
recycle the shipping carton when ever possible.
Introduction: The Titan™ 575W Moving Heads is part of OMEZ’s continuing pursuit for
creating high quality affordable intelligent fixtures.
This unit can be used as a stand alone, or be controlled via DMX controller.
LCD DISPLAY OPERATIONS
When light on, the display panel will showing DMX512 mode, press UP or DOWN to choose
press
MEUN/ENTER to confirm or into next, all the showing as following items.
1) DMX512 mode
2) DMX address, than press MEUN/ENTER the display shows DMX512 set 001, press UP or
DOWN to choose 002, 003,004, by analogy, press ESC to exit.
3) Conf ig set, press MEUN/ENTER the display shows CHANNEL SET, FAN SET and
TEMPERATURE SET, as CHANNEL SET, there are 3DMX modes to choose, as
STANDARD,EXTENDED and SHORT, press UP or DOWN to choose needed. As STANARD
mode has DMX 13channels, EXTENED mode has DMX 15channels, SHORT mode has DMX
9channels. Press ESC
to exit.
4) Option set, into this state, the display shows Pan invert and Tilt invert, as needed can be
selected.
5) Display set, into this state, the display shows Language set and display invert, as needed
can be selected.
6)Work mode, press MEUN/ENTER the display shows DMX512 MODE, SLAVE
MODE,SOUND MODE, DEMO MODE2 AND DEMO MODE1, press UP or DOWN to
choose, press MEUN/ENTER to confirm., press ECS to exit.

DIAGRAM FOR LCD DISPLAY
DMX 512 001 DMX address
setup DMX 512 002
Channel Standard
Fan Extend
Configuration Set
Temp Short
Pan Swap
Off
Pan Invert Pan Swap
On
Tilt Swap Off
Option Set
Tilt Invert Tilt Swap On
English
Language Chinese
Display Off
Display Set
Display Invert Display On
DMX512 Mode
Slave Mode
Sound Mode
Demo Mode i master
running
Work Mode
Demo Mode ii master
running
Power On
Hours Information
Power this time
To Factory
Mode Rest
System Reset

DMX Operation
13 Channel-DMX Mode
CHANNEL FUNCTIONS DMX Effects Note
1CH TOTAL 0-255 DIMMING
2CH R 0-10 no function red illumination
2CH R
10-255
red from
dark to
bright red illumination
3CH G 0-10 no function green illumination
3CH G
10-255
green from
dark to
bright green illumination
4CH B 0-10 no function blue illumination
4CH B
10-255
blue from
dark to
bright blue illumination
5CH W 0-10 no function white illumination
10-255
white from
dark to
bright
6CH STROBE 0-10 no strobe can work with 1CH-5CH
6CH STROBE 10-255
strobe from
slow to fast can work with 1CH-5CH
7CH MACRO Strobe 0-32
Standard
with strobe can work with 1CH-5CH
7CH MACRO Strobe
64
R
grounding
strobe
Can work with
1CH-5CH
7CH MACRO Strobe
96
RG
grounding
strobe can work with 1CH-5CH
7CH MACRO Strobe
128
G
grounding
strobe can work with 1CH-5CH
7CH MACRO Strobe
160
GB
grounding
strobe can work with 1CH-5CH
7CH MACRO Strobe
192
B
grounding
strobe can work with 1CH-5CH
7CH MACRO Strobe
224
BR
grounding
strobe can work with 1CH-5CH
7CH MACRO Strobe 255 illumination brightness without

depends strobe
8CH SPEED 0-255
9CH MACRO
Effects 0-10 no function 1CH-7CH can work
9CH MACRO
Effects 60 jumping 1CH-7CH no work
9CH MACRO
Effects 110 gradual 1CH-7CH no work
9CH MACRO
Effects 160 pulsing 1CH-7CH no work
9CH MACRO
Effects 210
static color
selection 1CH-7CH no work
9CH MACRO
Effects 255
sound
mode on 1CH-7CH no work
10CH X 0-255
11CH Y 0-255 no function
12CH RESET 0-254
system
reset
13CH RESET 255
DMX value reserved 3
second
Cleaning
Due to fog residue, smoke, and dust cleaning the internal and external optical lenses must
be carried out periodically to optimize light output.
1. Use a soft cloth to wipe down the outside casing.
2. Clean the external optics with a soft cloth every 20 days. Cleaning frequency depends
on the environment in which the fixture operates (i.e. smoke, fog residue, dust, dew).
OMEZ LIGHTING
11301 IRIS LN, #B
EL MONTE, CA 91731
www.omezlighting.com
Tel: 888-683-OMEZ
626-579-1890
E-mail: info@ omezlighting.com