Omnitech OMT-601 User manual

Handheld 125K EM4100 ID copier
GENERAL DESCRIP ION
It is designed to backup or duplicate the card ID from the EM4100 or compatible card format.
FEA URES
•Support 125 hz EM4100 or compatible card format only
•Standalone 2 buttons Simple operation
•don’t need connect with computer for operation
•Built-in LED and buzzer indicator
•Built-in transceiver antenna
•Battery power : 3V ( 2 x AAA battery )
•No external power is needed
•Portable design / size : (115 x 70 x 30) mm
Operation Manual – duplicate a EM4100 Card ID
[1] insert 2 x AAA battery here
[2] power switch on (Power red LED will flash per second)
(Low battery - if found fast “power LED” flash and “beep “ sound keep
continuously, need change a new battery)
[3] Place a EM4100 or compatible card on the reader’s detection area .
[4] press “Read” button ,
If the card format is correct , “Read” LED will be flash and “beep” 3 times
(If the card is not supported , No response from the reader)
[5] take away the EM4100 card and place a EM4100 RW Card or keyfob on the reader’s detection area.
Press “Write” button about ~1-2 second  If write success , will hear “beep” 3 times
(If R/W card type is incorrect, No response from the reader)
RFID Card Place Here
READ Button
Power Switch
LED indicator
Power read write
Write Button
OMT-601 125KHz-ID Reader