Onn 100013388 User manual

Cup Holder Phone Mount
With Wireless Charger
User Manual
Model: 100013388
CCH3355 (100013388) IB cover
Size: 7.5cm(W) x 10.5cm(H)
December 31, 2019_V1
We ‘d love to hear from you. Scan with your Walmart
app and let us know what you think.
681131 31077 2

1
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless the
modifications are expressly approved in the instruction manual. Modifications not
authorized by the manufacturer may void user’s authority to operate this device.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body. This transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter.

2
INSTALLATION
Before use, assembled the Car Mount to the Charger as follows:
1. Loosen the Knob on the Charger by turning it counterclockwise.
2. Insert the Car Cup Holder Phone Mount into the Charger.
3. Tighten it by turning the Knob clockwise.
MOUNTING
Mount the charger into your vehicle as follows:
1. Rotate the striped Circle on the Car Mount clockwise to outspread the three
Squares.
2. Outspread the three Squares to suitable position based on the diameter of Car
Cup Holder, Put the charger into the Car Cup Holder.
CONNECTION
Connect the Charger to your Car USB Charger (not included) as follows:
1. Connect the Micro USB Plug from the supplied USB connection cable to the Micro
USB Port on the Charger.
2. Connect the full size USB Plug to the USB Port on your USB Charger.
3. The Red Power On Indicator on the Charger will illuminate.
WIRELESS CHARGING
1. Mount the unit into your vehicle then connect it to your USB Charger as
previously instructed.
2. Press the Release Button on the rear of Charger to release the Clip.
3. Place your cell phone onto the Charging surface.
4. Adjust the location of cell phone by sliding the Holder up/down until the color of
the Red Indicator on the Charger turns to blue (or, the charging icon appears on the
cell phone’s display) to start charging.
(Note: If the location of the cell phone is incorrect, charging will NOT proceed.)
5. Closed the Clip to hold the cell phone.

3
Notes:
1. To charge a cell phone with the Charger, the cell phone must be compatible with
the Qi standard for wireless charging.
2. During charging, if the cell phone has a cover or case, it may disturb or prevent
the wireless charging function of the cell phone.
3. The charging transmission distance of the unit is less than 5mm, the thickness of
cell phone cover of case can NOT extend 8mm.
4. To maximize the charging speed, using a Car USB Charger (not included) equipped
with Quick Charger 3.0 USB port.
5. To save energy, disconnect the Charger from the Car USB Charger if not using it for
an extended period of time.
GENERAL SPECIFICATION
Wireless Charging Type: Qi version 1.2.4
Input:
DC
5V/2A or 9V/1.67A
Output: 5V/1A or 9V/1.2A
Transmission Distance: Up to 5mm
PACKAGE INCLUDES
1. Charger
2. Car Cup Holder Phone Mount
3. USB Connection Cable
4. User Manual
5. Quick Start Guide