Onvis S4UK User manual
Smart Plug S4UK
User Manual
QUICK START GUIDE
1. Make sure of a Thread network of a Thread Matter hub.
2. Reset the S4UK smart plug by long pressing the power button for 15
seconds until its LED blinks slowly.
3. Make sure the S4UK is within Bluetooth range with your phone, and
under coverage of the Thread network.
4. Launch the app (Apple Home, Google Home, Alexa or SmartThings) of
the respective ecosystem hub to add S4UK.
5. Tap ‘+’, and scan the Matter QR code on device or on user manual, or
manually input the setup code.
6. Name the S4UK and assign it to a room.
7. Talk to the voice assistant or use the ecosystem app to control On/Off.
Tips
1. The Matter QR/setup code can be used in the FIRST ecosystem Only.
2. To add S4UK to another Thread Matter ecosystem, please generate a
new QR/setup code from the previous ecosystem app.
3. Use the ecosystem app to create schedules, automations and scenes.
4. Use the ecosystem cloud to control S4UK away from home.
5. After setting up, S4UK will act as a Thread router to extend your Thread network.
6. Occasionally, the Thread network gets unstable, especially when a new
device is added. It might take up to 24 hours for the Thread network to
heal and adapt to the new structure.
7. When S4UK is unplugged, please wait at least 5 seconds before plugging
it back to power.
EN
Onvis Smart Plug S4UK Overview
LED Indication
• To be commissioned: Slow blinking
• Disconnected: Fast blinking
• Identify: Flashing twice
• Connected On: Solid On
• Connected Off: Solid Off
Power Button
• Long press to reset
Thread Matter hubs
For Apple Home:
• HomePod mini
• HomePod(2nd Gen)
• Apple TV 4K(2nd gen)
• Apple TV4K(3rd gen 128GB)
For Google Home:
• Nest Hub Max
• Nest Hub (2nd gen)
• Nest Wi-Fi Pro
For Alexa:
•4th-Gen Echo smart speaker
For SmartThings:
• SmartThings Station
• SmartThings Hub v3
Specifications
Model: S4UK
Input: AC 250V~, 50Hz
Output: Max. 13A / 3250W
Wireless Connection: 802.15.4 (Thread)
Commission: Bluetooth
Dimension: 59.5*59.5*62mm
FAQ
1. Why did I fail to set up my Onvis S4UK smart plug?
(1) Make sure Bluetooth is enabled in your iOS device.
(2) Make sure the S4UK is within Bluetooth range of your iOS device.
(3) Make sure your Thread network is in place and working, and the S4UK is within
Thread coverage.
(4) Input the correct MATTER setup code.
(5) Make sure the ecosystem app and hub supports Thread and Matter commissioning.
An Android device and app are required to commission to Google, Alexa and
SmartThings hubs(as of Jan 2023).
2. No Response
(1) If the connection of S4UK and the Thread network is too weak due to long distance,
try deploying a Thread router device to expand Thread network.
(2) When used in multi-ecosystems simultaneously, there might be delays or even
failures.
Net Weight: 88g
Material: V0 Fire-resistant PC
Operating Temperature: 0-40℃(32°F–104°F)
Operating Humidity: 5%-95% RH
Usage: Indoor use only
快速入門指南
1. 確保 Thread Matter hub 的Thread 網絡連接。
2. 長按電源按鈕 15 秒直至其 LED 緩慢閃爍，以重置 S4UK 智能插座。
3. 確保 S4UK 在手機的藍牙範圍內，並且在 Thread 網絡的覆蓋範圍內。
4. 啟動相應生態系統的應用程序（Apple Home, Google Home, Alexa 或
SmartThings）以添加 S4UK。
5. 點擊“+”，掃描設備或說明書上的 Matter 二維碼，或手動輸入設置碼。
6. 命名 S4UK 並將其分配給一個房間。
7. 與語音助手對話或使用生態系統應用程序以控制智能插座的開/關。
溫馨提示
1.Matter 二維碼/設置碼僅可在第一個生態系統中使用。
2.要將 S4UK 添加到另一個 Thread Matter 生態系統，請從之前的生態
系統應用程序生成新的二維碼/設置碼。
3.使用生態系統應用程序創建時間表、自動化和場景。
4.外出時，需要使用相應生態雲控制 S4UK。
5.設置完成後，S4UK 將充當 Thread 路由器來擴展您的 Thread 網絡。
6.Thread 網絡有時會不穩定，尤其是在添加新設備時。Thread 網絡可
能需要24小時左右才能恢復並適應新的結構。
7. 切斷 S4UK 電源後，請等待至少 5 秒再將其重新接入電源。
中文
Onvis智能插座S4UK概览
LED指示燈
•待配網：慢速閃爍
• 斷開連接：快速閃爍
• 識別：閃爍兩次
• 已連接：常亮
• 連接關閉：熄滅
電源鍵
•長按重置
Thread Matter hubs
For Apple Home:
• HomePod mini
• HomePod(2nd Gen)
• Apple TV 4K(2nd gen)
• Apple TV4K(3rd gen 128GB)
For Google Home:
• Nest Hub Max
• Nest Hub (2nd gen)
• Nest Wi-Fi Pro
For Alexa:
•4th-Gen Echo smart speaker
For SmartThings:
• SmartThings Station
• SmartThings Hub v3
參數
型號：S4UK
輸入：交流250V~，50Hz
輸出：13A/3250W（最大）
无线连接: 802.15.4 (Thread)
配網：蓝牙
尺寸：59.5*59.5*62mm
常問問題
1.為什麼我無法設置 Onvis S4UK 智能插座？
(1)確保您的 iOS 設備已啟用藍牙。
(2)確保 S4UK 在您 iOS 設備的藍牙範圍內。
(3)確保您的 Thread 網絡已就位並正常工作，並且 S4UK 在Thread 覆蓋
範圍內。
(4)輸入正確的 MATTER 設置代碼。
(5)確保生態應用程序和 Hub 支持 Thread 和Matter 調試。需要Android
設備和應用程序才能調試 Google, Alexa 和SmartThings hubs（截至
2023年1月）。
2.設備無反應
(1)如果由於距離較遠，S4UK與Thread 網絡的連接太弱，請嘗試部署
Thread 路由器設備來擴展 Thread 網絡。
(2)多生態系統同時使用時，可能會出現延遲甚至失敗的情況。
淨重：88克
材質：V0級防火PC
工作溫度：0-40℃
工作濕度：5%-95%相對濕度
用途：僅限室內使用
Warnings
• Indoor use only.
• Keep children away from the smart plug.
• Remove smart plug from power outlet before cleaning.
• Plug in power outlet directly. No extension power cord.
• Do NOT clean with liquid.
• Do NOT use over the electrical ratings.
• Do NOT attempt to repair the smart plug.
• Do NOT use in wet or damp areas.
• Do NOT use with devices that should not be operated unattended.
WEEE Directive Compliance
This symbol indicates that it is unlawful to dispose of this product together with other
household waste. Please take it to a local recycling center for used equipment.
Legal and Statements
• Use of the Works with Apple badge means that an accessory has been designed to work
specifically with the technology identified in the badge and has been certified by the
developer to meet Apple’s performance standards. Apple is not responsible for the
operation of this device or its compliance with safety and regulatory standards.
• Apple, Apple Home, Apple Watch, HomeKit, HomePod, HomePod mini, iPad, iPad Air,
iPhone, and tvOS are trademarks of Apple Inc., registered in the U.S. and other countries
and regions. The trademark “iPhone” is used with a license from Aiphone K.K.
• Amazon, Alexa and all related logos are trademarks of Amazon.com, Inc. or its affiliates.
Table of contents
