Opera Signature Dual Link Kit User manual

opera-care.co.uk | 0333 222 8584
Signature Dual Link Kit
Installation Guide
and Technical
Specications

1| Opera Care Signature Dual Link Kit Installation Guide | Version 1
1. Explanations of Symbols 2
2. Installation and Commissioning 3
3. General Information 11
4. Guarantee 13
5. Opera Warranty Terms and Conditions 13
Contents

2
opera-care.co.uk | 0333 222 8584 |
Read information with this symbol carefully and urgently follow instructions.
This information is safety-relevant.
This product must be disposed of in a seperate refuse collection in the European
Union. Do not dispose of as normal domestic waste.
Read Instructions
i
This symbol indicates hazards due to electrical voltage. There is mortal danger!
ELECTRICAL
1. Explanations of Symbols

3| Opera Care Signature Dual Link Kit Installation Guide | Version 1
(A) Receiver x 1 (B) Controller x 1
(C) Y Splitter Cable x 1 (D) Cable Clip x 4
(F) U Clamp x 2
(E) Actuator to Receiver Cable x 1
(G) Cable Connection Cover x 3
2.1 Contents
2. Installation and Commissioning

4
opera-care.co.uk | 0333 222 8584 |
Unpack the contents
Unpack the contents of the Signature Dual Link Kit and place to one side.
If the beds have side skirts, remove the skirts from the inner side of each
bed where they will be joined together. Refer to the Signature Proling Bed
Installation Guide on how to do this and the below step.
Unbrake the castors of the Signature Proling Beds and position the two
beds parallel to one another, with at least two meters between them. Brake
the castors once positioned.
Using the bed handset, electronically adjust the backrest of the beds to
gain access to the control boxes, this is where the link kit will be connected
to in the next steps.
1
Only unbrake the castors when the beds need moving to prevent rolling away and
injury. Turn off all power to the bed(s) after adjusting.
Signature bed Two parallel Signature beds
2. Installation and Commissioning
Read before you begin! Read this Installation Guide conscientiously before
installing the Signature Dual Link Kit
Signature bed with back and leg rest raised

5| Opera Care Signature Dual Link Kit Installation Guide | Version 1
Connect the Y splitter cable
Unplug the power cable of the bed (1) from the short power supply cable
(2) next to the control box (as per photos below).
Connect the two pronged plug of the Y splitter cable (3) to the power cable
(1).
Connect the socket on the splitter cable (4) to the two pronged head of the
short power supply cable (2).
Take a connection cover (G) and push the joined cables (the plug and
socket) into the cover, this should cover where the two cables connect.
2
1
2
F
3
4
2
4
2
2
4
3
1
G
C
2. Installation and Commissioning

6
opera-care.co.uk | 0333 222 8584 |
Connect the actuator to receiver cable
On the actuator to receiver cable (E), take the two pronged head (6) and
connect it to the remaining socket on the Y splitter cable (C).
Place the joined cable into a connection cover (G).
3
Connect the Receiver
On the actuator to receiver cable (E), take the round plug socket (8) and
connect to the plug (9) on the receiver (A).
4
6
7
6
8
8
9
E
C
G
E
E
A
2. Installation and Commissioning

7| Opera Care Signature Dual Link Kit Installation Guide | Version 1
Connect the Actuator
Unplug the height adjustment actuator cable from the control box, this is
the actuator plug that is colour coded with a yellow sticker (both on the
control box and on the plug).
Connect the receiver to actuator cable (E) socket (10) to the two pronged
plug of the height adjustment actuator cable (11).
5
10
11
10
E
E
2. Installation and Commissioning

8
opera-care.co.uk | 0333 222 8584 |
6Secure the actuator cable
Take two cable clips (D) and remove the self adhesive backing paper.
Attach the two cable clips on the chassis towards the control box and near
the backrest actuator (see below).
Attach these approx. 3.5cm apart. Pull open the cable clips and attached
the actuator cable as per the diagram below. Press the edge of the clips
down to lock the clips.
Secure the receiver
Take two cable clips (D) and attach them to the inside of the mattress
platform side channel, this needs to be at the side where the two beds will
be joined together. Place the cable clips approx. 5cm apart and approx.
13cm from the chassis securing bolt (12).
With one hand pull open the security clip and push the cable into the clip,
repeat this step for the second clip.
7
5cm
13cm
3.5cm
12
2. Installation and Commissioning

9| Opera Care Signature Dual Link Kit Installation Guide | Version 1
8Sync up the receiver and controller
Turn on the power to the bed. The receiver (A) light should turn on and the
LED on receiver the should turn yellow.
Insert the supplied batteries into the controller (B).
Press the pairing button (see photo below) on the receiver twice, the LED
should turn blue. You now have 10 seconds to pair the controller.
Press the up and down buttons of the controller simultaneously until the
LED on the receiver starts blinking. The blinking conrms successful
pairing.
To conrm successful pairing, use the controller (see photos below) to
raise and lower the bed by pressing the up and down buttons.
The distance between the receiver and controller should be no less than
two meters during synchronisation..
(A) Top of receiver (A) Side of receiver
Return beds to
orginal position Pairing button
LED
Raise bed
platforms up
Lower bed
platforms down
(B) Controller
2. Installation and Commissioning

10
opera-care.co.uk | 0333 222 8584 |
9Connect the second bed
On the second bed, unplug the height adjustment actuator cable from the
control box. This is the actuator colour coded with a yellow sticker.
Take the actuator to receiver cable (E) and connect it to the height
adjustment actuator, make sure that the long actuator to receiver cable is
under the mattress platform and out of the way of any moving parts.
Check that the second bed is connected to the receiver by raising and
then lowering the bed with the controller, both beds should simultaneously
raise and lower together.
Attach the beds together
Unbrake the castors on the beds and push the two frames together so that
they are ush.
Take one U bracket (F) and place it over the two joined frames at the head
end of the bed.
Insert the U bracket bolts through the holes in the bottom of the bracket
and tighten with an Allen key to secure.
Place the second U bracket over the two frames at the footend of the bed
and secure with the U bracket bolts.
10
ATTENTION: Use both of the supplied U brackets to ensure that the beds are
secured together. Always brake the castors after the beds have been repositioned.
2. Installation and Commissioning

11 | Opera Care Signature Dual Link Kit Installation Guide | Version 1
3. General Information
Read through this instruction manual from start to nish before using the
Signature Dual Link Kit.
3.1 Intended Use
The Signature Dual Link Kit may only be used under the conditions described
in this instruction manual. The Signature Dual Link Kit is designed to be used
together with the Signature Dual Proling Beds so that the bed platforms can
be raised together, simultaneoulsy.
3.2 Not Intended Use
All uses deviating from the intended uses will be classed as non-intended, this
will void the warranty terms and conditions. Non-intended uses include:
• Using the Signature Dual Link Kit for a use not outlined in this instruction
manual.
• Modifying the Signature Dual Link kit.
3.3 Warnings
Before installing the Signature Dual Link Kit it is recommended that the
Signature Dual Beds do not have any anything attached or on them, this
includes; Grab rails, side rails and mattresses.
During the brieng, specic attention must be drawn to any potential dangers
for the rst time, the instruction manual must be read conscientiously and in
detail by the user / care personnel.
Any incidents or issues must be reported to Opera at, support@opera-care.
Always brake the castors of the beds when the bed is in use, only unbrake
the castors when the beds need moving. Failing to observe this warning may
result in the bed rolling away and injury.
Only adults should operate and use the Signature Dual Link Kit, including the
controller.
i

12
opera-care.co.uk | 0333 222 8584 |
Specication data
Controller 2.4 GHz radio bidrectional controller
Bluetooth® Built-in
Floor lightining
under bed
Built-in
Power supply 29 V DC
Housing colour Black and White
Protection
degree
IP20
Relative air
humidity
30 to 75%
Ambient
temperature
10°C to 40°C
Do not lower or raise the beds without the consent of both occupants, failing
to observe this warning may result in entrapment and injury.
Read the Signature Proling Bed Installation Guide and Technical
Specications V2, before installing the Signature Dual Link Kit and operating
the beds. Failure to do so may result in serious injury, entrapment and electric
shock.
When operating the adjustment functions of the bed, ensure that the cables
do not get caught or pulled out.
3.4 Service Life and Disposal
The service life is dependent upon the manner of use. The Signature Dual Link
Kit must not be disposed of as normal household waste after the end of its
service life. Contact your local waste recycling facility for further instructions.
3.5 Specications
3. General Information

13 | Opera Care Signature Dual Link Kit Installation Guide | Version 1
4. Guarantee
As stated in the Standard Terms and Conditions, below, Opera provides a
manufacturer’s warranty of 1 year from the date of purchase.
5. Opera Warranty Terms and Conditions
5.1 Warranty Terms
5.1.1 Subject to the terms and conditions set out below, Opera agrees to
repair or replace the product within the United Kingdom at its own cost,
and any Opera accessory supplied with it, purchased by you from Opera.
In circumstances where the product does not perform in accordance with
Opera’s specications during the warranty period of 1 year, commencing
on the date of delivery (or deemed delivery) of the product.
5.1.2 This contractual product warranty does not operate to limit rights
under the statutory warranties referred to in clause 5.3.1 below.
5.2 Warranty Conditions
5.2.1 Proof of purchase (invoice) must be provided when requesting
service under warranty.
5.2.2 Opera requires any customer requesting service under the warranty
to comply with directions from Opera staff in relation to troubleshooting
any issue and facilitating any repair or replacement under these Warranty
Terms and Conditions.
5.2.3 The customer is responsible for inspecting all goods received from
Opera upon arrival. In instances where goods have been damaged in
transit, the customer must report this to Opera within 3 working days of
receipt of the product. Failure to report physical damage on arrival within
three working days of receipt may result in denial of warranty for physical
damage.

14
opera-care.co.uk | 0333 222 8584 |
5.2.4 Opera reserves the right to replace the product or relevant part with
the same or equivalent product or part, rather than repair it. Where a
replacement is provided, Opera will determine, in its discretion, the closest
product within the current range of products offered by Opera with which
to replace the faulty or damaged product. The replacement product may
differ with the replaced product in size and specications, at the
reasonable election of Opera. Opera may replace parts with refurbished
parts. Replacement of the product or a part under the warranty does not
extend or restart the warranty period.
5.2.5 If Opera is unable to repair or replace the product, the customer will
be provided with credit for Opera products or may be refunded the price of
the product (at Operas election). This credit or refund will be for the amount
of the purchase price of the product, excluding the associated delivery
cost.
5.2.6 In the event that a replacement, refund, or store credit is provided as
per section 5.2.5, the faulty item will become the property of Opera.
5.2.7 Opera may seek reimbursement of any costs incurred by you where
the product is found to be in good working order.
5.2.8 Opera reserves reasonable discretion to determine whether any
product is or is not performing in accordance with Opera specications,
subject to applicable law.
5.3 General
5.3.1 Legislation may imply warranties or conditions or imposes
obligations on Opera, which cannot be excluded, restricted or modied in
relation to consumer goods.
5. Warranty Terms and Conditions

15 | Opera Care Signature Dual Link Kit Installation Guide | Version 1
5.3.2 To the full extent permitted by law, but subject always to clause
5.3.1, the warranty will not apply in respect of a product:
(a) If the product has not been installed, operated, maintained or used in
accordance with the Opera instructions or specications provided with the
product;
(b) If the factory-applied serial number has been altered or removed from
the product;
(c) To damage, malfunction or failure resulting from alteration, accident,
misuse, abuse, re, liquid spillage, mis-adjustment of customer controls, use
on an incorrect voltage, power surges and dips, thunderstorm activity, force
majeure, voltage supply problems, tampering or unauthorised repairs by an
persons, use of defective or incompatible accessories, exposure to abnormally
corrosive conditions or entry by any insect, vermin or foreign object in the
product.
(d) To damage arising during transportation, installation or while moving the
product or to any transportation costs of the product or any parts thereof to
and from the customer, unless otherwise specied in these warranty terms
and conditions;
(e) To any third-party software or hardware not contained in the product as
originally congured by Opera.
(f) To any failure, to the extent that the failure is not a failure of the product to
perform in accordance with its specications.
(g) To service of any product whilst it is outside the United Kingdom.
5. Warranty Terms and Conditions

16
opera-care.co.uk | 0333 222 8584 |
5.3.3 To the full extent permitted by law, but subject always to clause
5.3.1:
(a) Opera will not be liable for any loss, damage or alterations to third party
products, no matter how occurring; or for any loss or damage arising from
loss of use, loss of prots or revenue, or for any resulting indirect or
consequential loss of damage.
(b) Opera’s aggregate liability in respect of all claims under the warranty
shall not exceed the original purchase price of the product or, at Opera’s
option, the replacement of the product with a like or similar product.
(c) Opera excludes all other warranties, conditions, terms, representations
and undertakings whether express or implied.
5. Warranty Terms and Conditions

17 | Opera Care Signature Dual Link Kit Installation Guide | Version 1
Notes

18
opera-care.co.uk | 0333 222 8584 |
Notes

Opera Care
Azure House, Connaught Road,
Kingswood, Hull. HU7 3AP
0333 222 8584
[e-mail]
opera-care.co.uk
Version 1 | Published September 2020