Opticon RS-3000 User manual

RS-3000
Quick Start Guide
1
24
3
Detach Attach
Push to
release the
scanner
Lift the
scanner
Rotate the
bracket
Push scanner
back into the
bracket until
you hear a click
Instructions left-handed and
right-handed use
2D CMOS
Imager
Adjustable
Strap
Reset Key/
Bluetooth Pairing
USB Connector
(Data/Charging)
Manual
Trigger
Trigger Key
Feedback LED

_QSG_RS-3000_04-2021
Quick Start Instructions
Configure
Your Scanner
Bluetooth Mode
HID (Keyboard
emulation)
SPP
For quick and easy
settings for your scanner
visit our website:
opticon.com/
configure-scanner
Bluetooth Pairing
Step 1 - Scan Bluetooth mode
Scan the Bluetooth Default barcode that matches
the connection method you wish to use. The
recommended mode is HID. The other mode is SPP
and will require an application on the target device.
Step 2 - Hold the function key for 5 sec
Hold the RS-3000’s function key for 5 seconds until
it beeps and begins to flash blue. The RS-3000 is
now discoverable by your host device. This can be
cancelled at any time by holding the function key for
another 5 sec.
Step 3 - Perform Bluetooth search on host
Use the Bluetooth interface on your host device to
search for and select the RS-3000. The RS-3000 will
beep to indicate success or failure. If you are pairing
in Bluetooth-SPP, the RS-3000 will complete the
pairing process as soon as you launch an appropriate
application and open the serial port created by your
Bluetooth software.
For information about your RS-3000, including
detailed setup instructions, downloads and more,
visit us at:
www.opticonusa.com/start/opn or
www.opticon.com/downloads
www.opticon.com