OrePac Building DOG HOUSE KIT User manual

DOG HOUSE KIT
FRONT & BACK PANELS (2x)
FLOOR PANELS (2x) ROOF RIDGE (1x)
READ ALL INSTRUCTIONS AND REVIEW DIAGRAMS
BEFORE BEGINNING THE INSTALLATION TO GET A
THOROUGH UNDERSTANDING OF THE PROCESS.
ROOF PANELS (2x)
SIDE PANELS (2x)
INSTALLATION GUIDE
WARNING: Cancer and Reproducve Harm www.P65warnings.ca.gov
2-1/2" BOLT & HEX NUT (8x) 1-1/4" WOOD SCREW (14x)
KIT INCLUDES

© 2018 OrePac Building Products. All rights reserved. OP-1118
WARNING: Cancer and Reproducve Harm www.P65warnings.ca.gov
Step 1
Step 3
Connect the front and back panel to each side using the
2 1/2" lag bolts and hex nuts (A).
Attach the roof to the top of the front and back panels using
the supplied 1 1/4" wood screws (B). Repeat the process for
the other roof panel using the remaining screws.
NOTE: there is a short wood cleat that will rest on the
two side panels to allow you to positions the panels.
OPTIONAL: use wood glue to permanently fasten (not included)
NOTE: in order to protect the wood on your dog house, it is recommended
to apply a protective stain nish or clear coat at least once a year.
Insert the two oor panels into the dog house.
Attach the roof ridge to the roof panels using the supplied
1 1/4" wood screws (B).
Step 2
Step 4