Origin Acoustics Foundation PA15 User manual

Foundation Collection™Manual
Installation Manual
PA
PA15 Pre-Amplifier
FOUNDATION COLLECTION™

Foundation Collection™Manual
Table of Contents
Introduction 1
What’s Included 2
Panel Overview 2
Specifications 3
Installation & Operation 4
Troubleshooting 6
Technical Assistance 7
Warranty 8
Return Process 9

1
Foundation Collection™Manual
Introduction
Thank you for purchasing PA15 Preamplifier from Origin Acoustics.
The PA15 can be a valuable tool to application areas such as residential or
commercial outdoor, landscape systems. It is a lightweight, compact and
portable unit, and can be used to boost input signals up to 18 dBV to achieve
more overall output.

2
Foundation Collection™Manual
What’s Included
1. Unbalanced RCA input
2. Input selector switch
3. Auxiliary input
4. Input volume control
5. On/O power switch
6. 24V DC Power
7. Auxiliary output
8. Unbalanced RCA output
Panel Overview
134
57 8
• PA15 Pre-Amplifier
• AC Adapter
• 3.5mm AUX to RCA cable (1m long)
6
AUXRCA AUX ININ
L R
VOLUME
MIN MAX
L R
AUX OUT
Manufactured in China
OUTDC 24V
OFF
ON
2

3
Foundation Collection™Manual
*All product specifications are subject to change. Please refer to the dealer portal for the latest information.
Specifications
MODEL PA15
PART PA15000
Frequency Response 20 Hz - 20kHz, ± 2 dB
Maximum Gain Limit 5 VAC
THD < .0003% @ 1 kHz
Maximum Output RCA:9V AUX:9V
Signal To Noise Ratio 114 dB @ Full Level
Gain Separation 80 dB @ 1000Hz
Output Gain 18 dBV
Input Impedance 10k ohms
Output Impedance 600 ohms
Dimensions 1 ” x 5 ” x 4 ” (45mm x 140mm x 106mm)
Weight 0.85 lbs (0.39 kg)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may
cause undesired operation.

4
Foundation Collection™Manual
Installation and Operation
Step 1
Access the rear of the source (CD/DVD player, computer, etc.), preamp and amplifier(s).
Locate the output jacks on the back of the source and the corresponding inputs on the preamp.
Step 2
Connect the source to the preamp using the RCA or Auxiliary connectors. Push in the connectors
from the audio outputs on the source to the appropriately-labeled inputs on the preamp
(labeled L & R IN or AUX IN).
Step 3
Find the RCA or Auxiliary preamp output cluster on the back of the preamp
(labeled L & R OUT or AUX OUT). Find the corresponding RCA inputs (L/R IN) on the back of the
amplifier(s).
Plug the connector cables from the preamp outputs to the matching inputs on the amplifier.
Step 4
Connect the preamp to the main power socket with the AC adapter. Press “ON” button to
turn the preamp on.
Tips
Shorter speaker cable runs, at the expense of longer RCA runs, allows better power transfer
to the speaker.
Warning
Do not make preamp/amp connections with the system turned on.
Items you will need to connect PA15 preamp to amplifier:
• RCA connector cable (not included)
• 3.5mm AUX to RCA cable (included, 1m long)

5
Foundation Collection™Manual
NOTES

6
Foundation Collection™Manual
Troubleshooting
If possible, it’s oen good to try to isolate the problem first. For example, if you’re
playing a DVD on a television and there’s no sound, try connecting an MP3 player
to the system to see if that works. If it does work, then the problem is with the tele-
vision, DVD player, or the cables connecting them. If it doesn’t work, the problem
will be with the amplifier, speakers, or those cables.
Problem Possible Cause
No Sound The volume may be turned down or muted. Check the volume
settings on both the amplifier and the television/computer/CD
player/etc.
No Sound Make sure the proper source is selected on the amplifier or receiver.
No Sound Check the cord connecting the amplifier with the source. The cord
may be damaged or plugged into the wrong input or output.
No Sound Check the wires connecting the amplifier with the speakers. Make
sure they’re connected properly and not damaged in any way.
Poor Sound
Quality
If you hear something like static, or the sound is cutting in and out,
check the audio cables. If the problem increases when a cable is
being moved, then the cable is most likely faulty or not connected
properly.
Poor Sound
Quality
Today’s audio systems may have several places to adjust the
volume, for example your MP3 player may have a volume control,
and your amplifier may also have one. Check to be certain that the
volume isn’t turned up past 80% on any device.
Poor Sound
Quality
Try changing sources to be certain that the selection you’ve
chosen is a good quality recording.

7
Foundation Collection™Manual
If you have any questions or concerns about installing or using this product, you
can reach us through one of the following methods:
Phone: [phone]
Hours of operation: 8:00am - 5:00pm (Pacific Time), Mon - Fri
Email: [e-mail]
If you are having technical trouble, please include the model number and
briefly explain what steps you took to resolve the problem in your email, or
be prepared to answer these questions over the phone. If you are considering
returning the product, it’s required that you contact Origin Acoustics prior to any
return attempts. This way we can determine if the issue can be resolved without
returning the product, or if needed we can provide instructions and support for
the return process.
Technical Assistance
Problem Possible Cause
No Sound The volume may be turned down or muted. Check the volume
settings on both the amplifier and the television/computer/CD
player/etc.
No Sound Make sure the proper source is selected on the amplifier or receiver.
No Sound Check the cord connecting the amplifier with the source. The cord
may be damaged or plugged into the wrong input or output.
No Sound Check the wires connecting the amplifier with the speakers. Make
sure they’re connected properly and not damaged in any way.
Poor Sound
Quality
If you hear something like static, or the sound is cutting in and out,
check the audio cables. If the problem increases when a cable is
being moved, then the cable is most likely faulty or not connected
properly.
Poor Sound
Quality
Today’s audio systems may have several places to adjust the
volume, for example your MP3 player may have a volume control,
and your amplifier may also have one. Check to be certain that the
volume isn’t turned up past 80% on any device.
Poor Sound
Quality
Try changing sources to be certain that the selection you’ve
chosen is a good quality recording.

8
Foundation Collection™Manual
Origin Acoustics warrants to the original retail purchaser only that this Origin
Acoustics product will be free from defects in materials and workmanship,
provided the speaker was purchased from an Origin Acoustics authorized dealer.
If the product is determined to be defective, it will be repaired or replaced at
Origin Acoustics’ discretion. If the product must be replaced yet it is no longer
manufactured, it will be replaced with a model of equal to or greater value that is
the most similar to the original. If this is the case, installing the replacement model
may require mounting modifications; Origin Acoustics will not be responsible for
any such related costs.
2 Year Limited Warranty
This warranty may not be valid if the product was purchased through an
unauthorized dealer. This warranty only applies to the individual that made the
original purchase, and it cannot be applied to other purchases. The purchaser
must be prepared to provide proof of purchase (receipt). This warranty will not
be valid if the identifying number or serial number has been removed, defaced,
or altered.
Requirements & Warranty Coverage
*All warranties and warranty conditions are subject to change. Please refer to
www.originacoustics.com for the latest information.

9
Foundation Collection™Manual
• Accidental damage
• Damage caused by abuse or misuse
• Damage caused by attempted repairs/modifications by anyone other than
Origin Acoustics or an authorized dealer
• Damage caused by improper installation
• Normal wear, maintenance, and environmental issues
• Damage caused by voltage inputs in excess of the rated maximum of the unit
• Damage inflicted during the return shipment
Not Covered by Warranty
Before making any return attempts, it is required that you first contact Origin
Acoustics. Return product to Origin Acoustics or your dealer, either in person or by
mail. It’s preferable if the product is returned in the original packaging. If this isn’t
possible, the customer is responsible for insuring the shipment for the full value of
the product.
This warranty is in lieu of all other expressed or implied warranties. Some states do
not allow limitations on implied warranties, so this may not apply depending on
the customer’s location. (For more information, see Magnuson-Moss Warranty Act.)
Return Process

6975 S Decatur Blvd, Las Vegas, NV 89118 • www.originacoustics.com • 844-674-4461
©2019 Origin Acoustics. All copyrighted, trademarked and patented elements mentioned herein are the sole property of Origin Acoustics.