ORTEC OD347-2X2D User manual

WARNING
LED Back Lit Panels
MODEL OD347-2X2D
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a competent electrician.
INSTALLATION GUIDE
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY
A QUALIFIED ELECTRICIAN.
1. LED Back Lit Panels are suitable for using in dry and damp locations
2. Please keep the LED Back Lit Panels away from any corrosive substance, and please use
dry cloth when you clean it
3. LED Back Lit Panels can only be installed by a qualified electrician
4. Before installation or maintenance, please disconnect the power to prevent electric shock
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Mississauga, ON L5T 2N1
CAUTION
Recessed Installation
1) 2)3)4)
1) Remove the ceiling tile at an
appropriate location where the
product is to be installed and
raise the product above the bar
2) With power turned OFF at the
2) breaker, connect power to
2) driver based on
2) wiring diagram
3) Fix the product protection
3) bracket above the T-bar and
3) insert the luminaire into
3)the panel
4) Adjust appropriate
4) orientation and
4) complete the
4) installation
Surface Mount Installation (pt.1)
1) 2)3)
1) Fix A1 / A2 / B1 / B2 by
screws, making it a
complete frame
2) Then fix A1 / A2 / B2 at the ceiling
2) and screw off B1
3) Embed part of the luminaire into the
3) ceiling mounting equipment.
3) With power turned OFF at the
3) breaker, connect power to driver
3) based on the wiring diagram

Surface Mount Installation (pt.2)
INSTALLATION GUIDE
4)4) Push up luminaire into
4)the frame seamlessly
5) Screw up B1 with screws and
5) the surface mount installation
5) is complete
5)
LED Back Lit Panels
MODEL OD347-2X2DInstruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Mississauga, ON L5T 2N1
The Suspending Installation
1)2)
1) Position the expanded screws at one end of the
cable on the ceiling and hook the other end of
cable on panel
2) Connect the screw cap to the expanded nut of
2) the ceiling. With power turned OFF at the
2) breaker, connect power to driver based on the
2) wiring diagram to complete the installation
ORTECH reserves the right to modify at any time, without notice,
any or all of our product's features, designs, components and
specifications to meet market changes.