Osborne Journeyman 1186 Installation guide

Thank you very much for choosing Osborne for your table project.
Instructions for Assembling Osborne Part 1186
Journeyman Pedestal Base
In this box:
One pedestal center with pre-drilled holes (see picture part A)
Four pedestal feet with bolts, nuts, and washers on one end (see picture part B)
Four pedestal arms with bolts, nuts, and washers on one end (see picture part C)
Eight cross-brace pieces with bolts, nuts, and washers on both ends (see picture part D)
You will need:
½” Wrench, or Ratcheting Socket Wrench
Screwdriver (flathead or Phillips)
Ruler
Instructions:
1. Locate the cross-brace pieces. The angles on the ends are different. The flat on one end is 2 7/8” long and the
flat on the other end is 3 ½” long.
2. Line up the cross-brace pieces with all of the 2 7/8” sides closest to you. This will be the side to insert into the
feet and arms.
3. Locate the pedestal feet. The feet have the black plastic levelers installed on the bottom.
4. Loosely attach one cross-brace piece to one foot piece. Make sure the 2 7/8” long flat is against the foot. When
installed, the hanger bolts on the foot piece and on the cross-brace piece will point in the same direction.
5. Repeat with the other three feet pieces.

6. Stand the pedestal center on one end (both ends are the same).
7. Insert the hanger bolts on the foot and cross-brace assembly into the pre-drilled holes on the pedestal center.
(When properly installed, the cross-brace and foot should easily insert into the pedestal center.)
8. Level and tighten the foot first. Then tighten the cross-brace at the center. Lastly, tighten the attachment of foot
and cross-brace.
9. Repeat with the other three feet.
10. Locate the pedestal arms. The arms do not have levelers installed. (There may still be an extra predrilled hole on
the arms.)
11. Loosely attach one cross-brace piece to one arm piece. If the arm piece has an extra pre-drilled hole use the hole
closest to the middle of the piece. Make sure the 2 7/8” long flat is against the arm. When installed, the hanger
bolts on the arm piece and on the cross-brace piece will point in the same direction.
12. Repeat with the other three arm pieces.
13. Flip the pedestal center over so that the attached feet are on the floor.
14. Insert the hanger bolts on the arm and cross-brace assembly into the pre-drilled holes on the pedestal center.
15. Level and tighten the arm first. Then tighten the cross-brace at the center. Lastly, tighten the attachment of arm
and cross-brace.
16. Use a screw driver to adjust the levelers on the feet as needed.
Copyright Osborne Wood Products, Inc. 2020