OtoPet-USA LS-150 Setup guide

LS-150 USB Light Source
with Video Capture
Setup and Operation
OtoPet-USA is a division of DermaZooTM
8909 Iverleigh Court, Potomac, MD 20854
Ofce: 301-365-0192 • Toll Free: 866-374-0897
Fax: [phone] • Email: [email protected]
www.OtoPet-USA.com
OTOPet-USA
TM

OtoPet-USA LS-150 Light Source with Video Capture Manual
If you have VetScope View, follow these instructions.
If you don’t have this lightsource connected to a
computer, skip to the asterix (*) below. Make sure your
light source and camera are on.
Inside the VetScope View software, go to: Edit, Video
Preferences
Video Settings - VetScope View
After clicking on Video Preferences, the Video Options
menu will allow you to set the input type.
Set the Input type to Composite and File format to
WMV.
*LS-150 Super Cable connecting to LS-150 USB.
Plug the camera cable into the cable socket on the left
side of the Light Source. Align the arrow head with the
top of the socket and press into the socket.


3
OtoPet-USA LS-150 Light Source with Video Capture Manual
Video Settings - VetScope View continued
Camera Connections
Twist the Composite BNC 1/4 turn onto the male connnection on the rear of the mini-camera.
Insert the power cable into the socket marked DC12V on the rear of the camera as shown.
BEFORE AFTER
Press down on the lever as shown to the right to insert
the light cable.


OtoPet-USA LS-150 Light Source with Video Capture Manual
4
OtoPet-USA LS-150 Light Source with Video Capture Manual
Rear Connections
Connect the power cable into the Power Inlet socket in the rear of the LS-150 USB Light Source. Connect a USB cable from
your computer to the socket marked USB. If connecting directly to a monitor, plug an RCA/BNC cable into the connection
marked Composite Video. The other end of the cable will connect to a video-in socket in your monitor.

Remove the light cable from the by pressing down on
the lever that protrudes from the aluminum light cable
receiver block as shown below. Pull the cable from the
receiver block while pressing down on the lever.
COMPUTER CONNECTION MONITOR CONNECTION

Disconnect the video cable by simultaneously press-
ing the tab on the camera socket and pulling the black
connector out of the LS-150 USB.