Outdoor Essentials HOMESTEAD RUSTIC 2X8 ELEVATED GARDEN PLANTER User manual

AB
F
B
EE
C
A
D
G
A
B
CH
EA
D
PARTS DIAGRAM
Tools Needed
IMPORTANT TIPS
6 – Legs
3 – Short boards (no cleat)
2 – Long boards (no cleat)
2 – Long boards with cleat
3 – Short end boards with cleat
3 – Notched floor boards
24 – Straight floor boards
54 – Screws
A
E
C
G
B
F
D
H
• Power drill with #2 Phillips bit
(recommended) or a screwdriver
• Work gloves
• Landscape Liner
(included with some styles)
• •
Pg. 1
HOMESTEAD RUSTIC ELEVATED GARDEN PLANTER – ASSEMBLY INSTRUCTIONS
Kit Contents
• Maximum soil load – 1040 lbs
• Place planter on level, even ground.
• Do not overdrive screws. Avoid driving screws through or into knots.
• Place soil evenly across the bed - don’t dump a whole bag in at once.
14059_2/22
HOMESTEAD RUSTIC 2X8 ELEVATED
GARDEN PLANTER  ASSEMBLY INSTRUCTIONS
ACTUAL SIZE: 94 in. L x 28 in. W x 311/2 in. H

Pg. 2
HOMESTEAD RUSTIC ELEVATED GARDEN PLANTER – ASSEMBLY INSTRUCTIONS
STEP 1 ASSEMBLE THE TWO ENDS
STEP 2 ASSEMBLE THE MIDDLE
STEP 3A ASSEMBLE THE SIDES
• Place one short board (B) and one short end board
with cleat (E) onto the legs (A) as shown. Secure
with screws (H) through the predrilled holes.
• Repeat with second side.
• Place one short board (B) and one short end board
with cleat (E) onto the legs (A) as shown. Secure with
screws (H) through the predrilled holes.
• Turn the two ends on their sides as shown,
cleat facing in.
• Place one long board (C) and one long board with
cleat (D) onto the legs as shown. Secure with
screws (H) through the predrilled holes.
B
B
E
E
A
A
cleat
faces in
cleat
flush
flush
flush
flush
C
B
TOP VIEW
C
D

Pg. 3
HOMESTEAD RUSTIC ELEVATED GARDEN PLANTER – ASSEMBLY INSTRUCTIONS HOMESTEAD RUSTIC ELEVATED GARDEN PLANTER – ASSEMBLY INSTRUCTIONS
STEP 3B ASSEMBLE THE SIDES CONTINUED
STEP 4 ATTACH THE MIDDLE TO THE SIDES
• Carefully flip the planter over.
• Assemble the second side as shown, following
instructions in Step 3A.
• Slide the middle into the frame and attach to the sides
as shown. Be sure the screws are centered into the
middle of the legs.
flush
flush
C
D
TOP VIEW
C
B
TOP VIEW
C
D

©2022 UFP Retail Solutions, LLC. Outdoor Essentials is a registered trademark of UFP Industries, Inc.
All rights reserved. 2801 E. Beltline NE, Grand Rapids, MI 49525 14059_2/22
OutdoorEssentialProducts.com
THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT MEANT TO REPLACE A LICENSED PROFESSIONAL. ANY CONSTRUCTION
OR USE OF THE PRODUCT MUST BE IN ACCORDANCE WITH ALL LOCAL ZONING AND/OR BUILDING CODES. THE CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH
THE CONSTRUCTION OR USE OF THIS PRODUCT. THE CONSUMER OR CONTRACTOR SHOULD TAKE ALL NECESSARY STEPS TO ENSURE THE SAFETY OF EVERYONE INVOLVED IN THE
PROJECT, INCLUDING, BUT NOT LIMITED TO, WEARING THE APPROPRIATE SAFETY EQUIPMENT. EXCEPT AS CONTAINED IN THE WRITTEN LIMITED WARRANTY, THE WARRANTOR DOES
NOT PROVIDE ANY OTHER WARRANTY, EITHER EXPRESS OR IMPLIED, AND SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.
HOMESTEAD RUSTIC ELEVATED GARDEN PLANTER – ASSEMBLY INSTRUCTIONS
Pg. 4
STEP 5 ASSEMBLE THE FLOOR
STEP 6 INSERT LANDSCAPE LINERS
• Drop in the floor boards with notches (F) into the
spaces that butt up against the legs as shown.
• Insert the straight floor boards (G) to complete
the floor.
• Insert landscape liner in bed before adding soil.
You will need approximately 12 cubic feet of soil to
fill the planter.
G
Note: If planting consumables,
an impermeable liner is required
(sold separately). Punch holes in
bottom for draining.
Note: Boards will have small gaps in
between them to allow for drainage.
G
F