
3. Take bolts (D) and place them into brackets (C) so that the bolts will stay locked with brackets (C).
4. Slide 2 brackets (C) with their bolts (D) into attachment rails with threads facing down. Do the same for the
second attachment rail.
5. Have two or more persons place the tent atop the vehicle onto roof rack or crossbars.
6. Once the tent is positioned, insert bolts (D) through bottom brackets (B), so that brackets (B) clamp the tent
against the rack or crossbars. Do NOT keep tightening after it has already started to bend as this will make it difficult
to mount again in the future.
IMPORTANT: Apply lubricant to the bolts and nuts before tightening to prevent thread galling.
7. Repeat the procedure for the remaining 3 brackets. NOTE: Check that the tent is securely attached after a short
distance, and thereafter at regular intervals. Tighten the mounting brackets whenever necessary.
INSTALLING THE LADDER
CAUTION: FAILURE TO PROPERLY SECURE THE LADDER COULD CAUSE DAMAGE AND SERIOUS INJURY.
CAREFULLY READ THE INSTRUCTIONS BELOW BEFORE ATTEMPTING TO USE THE LADDER.
The ladder acts as the support for the tent’s extension panel. Always make sure the ladder is firmly planted in
the ground, and each step is securely locked before going up the ladder.
1. Gather hardware (E)
2. Find four pre-drilled holes on one end of the tent
floor.
3. Install brackets into four pre-drilled holes using
the four nuts and bolts seen in picture.
4. Once brackets are secure, place ladder against
brackets with ladder stickers facing outwards.
5. Attach ladder to brackets using the two small
nuts and bolts seen in picture. NOTE: Make sure
all hardware is tight before ladder use.