Ovente MPT851 10 Series User manual

WARRANTY
Register your product within 30 days of purchase to activate your one-year
limited manufacturer’s warranty at ovente.com/register
WARRANTY IS ONLY VALID IF YOU REGISTER WITHIN 30 DAYS AFTER
PURCHASE.
LIMITED ONE (1) YEAR WARRANTY
Your product has a one (1) year warranty period starting on the date of purchase from an
authorized retailer. In the event that the product is defective, please contact us to
arrange for a replacement. This warranty only covers defects in workmanship and
materials. The warranty does not include damage due to misuse, commercial use,
accidents, or natural wear and tear.
LIMITATIONS
The warranty stated above is the only warranty applicable to this product. Other
expressed or implied warranties are hereby disclaimed. No verbal or written information
given by the Manufacturer, its agents or employees shall create a guarantee or in any way
increase the scope and duration of this warranty. Repair or replacement as provided
under this warranty is the exclusive remedy of the consumer. The manufacturer shall not
be liable for incidental or consequential damages resulting from the use of this product.
Any implied warranty of merchantability or fitness for a particular purpose on this product
is limited to the applicable warranty period set forth above except to the extent prohibited
by law. Consumer rights may vary from state to state.
Customer Service: [phone]
Visit us at ovente.com

8.5” Dual-Sided Tabletop Mirror
with 3 Tone LED Light Option, 1x/10x
MPT851x10x Series
Before using please read the instruction manual and keep it for future use.
ovente.com

IMPORTANT SAFEGUARDS
When using your mirror, basic safety precautions should always be followed, including the following：
Read all instructions carefully before use.
Provide close supervision when mirror is being used near children.
Never operate mirror if it is not working properly, has been dropped, damaged, or submersed in water.
Do not use outdoors.
Do not disassemble the mirror. Do not attempt to remove, alter or replace the permanent LED light.
Never operate where aerosol (spray) products are being used, or where oxygen is administered.
Be sure mirror is not in a position where it can reflect sunlight. Reflected sunlight can cause fire.
Always switch the mirror OFF after use and unplug before storing.
USING THE MIRROR
1. To turn on lights, simply touch the switch as shown.
2. Choose from different light options such as:
-Cool White: for a much brighter clear color which enables you to see
every imperfection.
-Warm White: depicts a more flattering look that is perfect for a date
night or special occasions.
-Natural White: A sharper light replicating daylight.
3. After use, always touch the switch button to “OFF”.
Leaving the mirror on longer will reduce battery life.
4. Mirror is equipped with built-in energy saving timer that shuts it off
after 15-minute of use.
Magnification Effect
NOTE: When you are farther from the mirror, the image is inverted. As you get
closer, the image flips to the actual virtual image in magnification standard. This is
due to the concavity of the mirror.
Battery Replacement
The battery compartment is located on the bottom side of the appliance. To replace the batteries, use the following instructions:
1. Before attempting to replace batteries, touch the switch button to OFF and unplug adapter.
2. Turn mirror upside-down.
2
ovente.com

3. Locate battery compartment cover.
4. Use your finger to open the battery cover. Replace with four (4) AA
batteries. All four batteries must be
present and properly positioned for the mirror to operate.
5. Once the batteries have been inserted, replace the battery
compartment cover.
6. The mirror is now ready for use.
NOTE:
-It is recommended to always use high quality lithium batteries to maintain its
maximum performance.
-Upon using the mirror in 15 minutes increment daily between 30-40uses, the brightness
of the mirror will decrease by up to 20%.
-The use of natural light option may cause faster battery consumption than when using
the cool and warm light option.
-Once the touch switch is no longer responding properly, it is an indication to replace
with new batteries.
AC Adapter
1. Locate the socket on the base of the mirror.
2. Connect the AC adapter.
3. Turn ON the mirror using the touch switch function.
CARE/DISPOSAL OF ALKALINE BATTERIES
Use only fresh batteries of the required type and size.
Do not mix old and new batteries, different types of batteries, or rechargeable
batteries of different capacities.
Depleted batteries are to be removed from the item.
Dispose of the old batteries properly and according to your local regulations.
MIRROR MAINTENANCE
1. Make sure that LED lights are OFF before cleaning.
2. Use a soft wet cloth to remove dirt and stains. Wipe with dry cloth afterwards.
3. To protect the mirror from dust simply store it in its original box. Store out of reach of children in a safe
dry location.
TECHNICAL SPECIFICATIONS
Input Voltage: 6V (Battery) / 110V (AC Adapter)
Power: 9W
Hertz: 50/60Hz (AC Adapter)
3
ovente.com