Oxford & Garden DARTMOOR STOOL 204131399 User manual

Components
1Seat
QUANTITY: 1
2Front Leg
QUANTITY: 2
3Rear Leg
QUANTITY: 2
4Foot Rest
QUANTITY: 1
DARTMOOR STOOL
ITEM NUMBER 204131399
OXFORD GARDEN
OXFORD GARDEN
1
729 Research Drive, Unit A Louisville, Kentucky 40299
877.866.3331 (fax) 502.719.8888
Congratulations
Congratulations, and thank you for your purchase of a finely
crafted piece of furniture from Oxford Garden. Enclosed
in this document are assembly instructions. Please take a
moment to read this information before putting your furniture
together so as to avoid any confusion regarding parts and
instruction. Wehope you enjoy your new outdoor furniture…
About Shorea Wood
Shorea is a tropical hardwood that grows plentifully in the
Pacific Rim countries of Burma, Malaysia, and Indonesia.
Shorea is closely related to teak, and is therefore well suited
for use in furniture making. It is renowned for its strength,
durability, and beauty. Like teak, shorea has natural oils that
allow it to withstand the effects of sun, rain, snow, and frost.
For information about wood care and maintenance, please
visit our website: oxfordgarden.com under “product care”.
Assembly Instructions page 1 Dartmoor Stool
Hardware
Dowels
QUANTITY:10
Finishing Items (included)
Medium Grit Sandpaper
NOTE: A hammer (not provided) will be
needed for the assembly of this bar stool.
NOTE: If the furniture is going to be placed
on a concrete or tile patio, it should first
be rinsed well to remove the sawdust
that may cause some staining.
A

Assembly Instructions page 2 Dartmoor Stool
Step 1
On a clean flat surface, lay one right front leg 2 (front leg has
two lower mortise holes), and one right rear leg 3 (rear leg has
one lower mortise hole) on their sides mortise holes facing up.
Step 6
Enjoy your new bar stool!
Step 2
Line up the seat 1 , and insert into the legs.
Step 4
Place one left front leg 2 and one left rear leg 3 onto the
parts already assembled.
Step 3
Line up the foot rest 4 , and insert into the legs.
Step 5
With a hammer, drive 10 total dowels Ainto the predrilled holes on
the inside of the front and rear of the legs 1 . Insert the tapered
end of the dowels first. NOTE: The dowels should be easily driven in
flush. If there is strong resistance, do not force the dowel. Sand to
smooth off areas around the dowel pins.
A
2
3