Oxford & Garden SIENA CLUB CHAIR User manual

15 Kingbrook Parkway, Suite 100 Simpsonville, KY 40067 p. 877.866.3331 f. 502.719.8888 oxfordgarden.com
Ver. 06.30.20
SIENA CLUB CHAIR - SCC
ASSEMBLY INSTRUCTIONS
COMPONENTS
HARDWARE
FINISHING ITEMS
Medium Grit Sandpaper
NOTE: If the furniture is going to be placed on a concrete or tile patio, it should first be rinsed well
to remove the sawdust that may cause some staining.
NOTE: Hardware pack may contain extra hardware
4
3
Back
Quantity: 1
Seat
Quantity: 1
Long Bolts
Quantity: 2
A
Short Bolts
Quantity: 6
B
Guiding Bolt
Quantity: 1
C
Barrel Nut
Quantity: 8
D
Dowels
Quantity: 4
E
Allen Wrench
Quantity: 1
F
B

Ver. 06.30.20
INSTRUCTIONS
STEP 1
NOTE: This item uses tight tolerances, it is important to
follow the steps in the order shown here. Lay leg assembly
on flat surface and insert back assembly as shown.
STEP 2
See bottom notes on how to align barrel nuts and bolts.
Using the provided allen wrench and guiding bolt ,
secure TOP of the back with barrel nut and LONG bolt
as shown. Secure BOTTOM of the back as shown using
barrel nut and SHORT bolt .
NOTE: Do not tighten down in this step, leave loose until all
bolts are inserted, then tighten all bolts. Be certain not to
over tighten.
Ver. 2019.8.10
STEP 3
Next, insert the tenons on the seat assembly into the
leg assembly as shown.
STEP 4
Using the provided allen wrench and guiding bolt ,
secure seat with barrel nut and SHORT bolt as shown.
STEP 5
Insert the remaining leg assembly into the assembled parts and
repeat steps 2 and 4 to secure. Next, further secure the seat to
the leg assemblies by driving two dowels into the mortise
holes as shown.
1A
4
C
B
E
4
1
4
2
2
D
A
B
1
D
D
How to align barrel nuts and bolts.
Insert a guiding bolt into the end of a barrel nut. Align the barrel nut inside of the component with the bolt used to
connect the components. Once the component bolt is aligned and threaded, simply pull the guiding bolt from
the end of the barrel nut.
2C
B
D
D
D
B
B