OXO LIPS 16 Installation instructions

User Manual
24-004-1459
Rev1.0 August 2004

LIPS 16 User's Instruction
What's the LIPS 16
Thank you for your purchase this simple and convenient product. This unit is a 512 DMX
controller, which can control consecutive 16 channels from the start address each time. It can
be easily set the start address by Up /Down keys and adjusted the channels values by 16
faders. And it has a useful LED display window for operation. What is more, owning power
failure memory, this unit can recover the previous settings.
Safety Instructions
When unpacking it, please check it up carefully for sure that this product is not damaged and
all accessories are not missing. If there's any problem, contact the local dealer or distributor
without hesitation.
Cautions
Do not make any inflammable liquids, water, or metalcontact it.
Keep away from the strong magnetic fields.
Reduce the risk of electric shock or fire when using this unit.
Packaging material must not be left within children' reach, as it can be dangerous.
Specifications
DMX Out: 3 pin female XLR connectors
Power requirement: 9VDC, 300 mA ( Including an AC~ DC adaptor )
Dimension: 482mmx 132mm x 80mm
Weight: 2.30 kg
Copyright Notice
All rights reserved. No part of this manual may be reproduced in any form or by any
means without written permission. Improvement and changes to specification, design,

1. When switching on the power supply, the LED window will display the start DMX channel
address. It can be "A001". If there are no character and number display, check the power
whether it's correctly connected.
2. The default start address for controlling the DMX channels is channel 1. To adjust the initial
start address, you can press the Up key to increase it by 1. When holding the Up key for 1
second, the start address will increase rapidly from the initial value to the desired value. You
can also press the Down key to decrease the present value by 1. When holding the Down key
for 1 second, the present value will decrease rapidly to the desired value.
.
NOTE: Whenever you want to adjust the start address, press Up key or Down key to shift the
start address setting mode. In this case, you may change the start address temporarily. You
can control the 16 continual DMX channels from the beginning of the starting address. The start
address must be 1 ~ 512. And the overflowing channels will not be proceeded.
3. Pushing the channel fader, one of the 16 channels faders, can allow you to adjust the relative
channel value. The LED will display the value temporarily with the default mode of decimal
( 0 ~ 255 ) when sliding the fader. For percent display mode, you can press the MODE key.
In this case, the indicating LED of right lower corner will be out in the display window and
the indicating LED of right higher corner will be lit up.
Fader
Mode
Up
Down
Master
Fader
After you have set the 16 channels values, waiting about 10 seconds, the LED window will
automatically show the start address.

4. Master fader
Pushing the Master fader can control the output values of all the 512 channels.
The output value can be set to 0 ~ 255 by the Master fader. There are also two display modes,
including decimal and percent mode. The default mode is decimal mode. And you can shift
between these two modes by pressing the mode key.
Rear Panel
PUSH
POWER DMX OUT
Dc Input:
9VDC, 300mA
Made in PRC 23-001-1951
1=Ground
2=Data-
3=data+
Power Input Power Switch DMX Output
1. Power Input: DC 9V, 300mAMin.
2. Power Switch: Turn on/off the mains power.
3. DMX Output: 3-pin XLR female socket