OYPLA Home 4476 User manual

User Manual
USER MANUAL Model No: 4476
Four Tier Unit

Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold
on this condition, which no representative of the company can waive or change.
USER MANUAL Model No: 4476
Make sure all fastenings are tightly in place and that everything is in order before
using the product. This should be periodically checked by an adult.
Do not discard any of the packaging until you have checked that you have all of
the parts and fittings required.
This product is not a toy, and is only to be used for its designated purpose.
Do not carry out alterations or modifications to this product.
Clean only with a damp cloth. Do not use strong industrial cleaning substances or
abrasive materials as these will damage the product.
Make sure all platforms are secure before applying any weight to the product.
This product is intended for indoor use only.
Only use this on stable, level and dry ground.
This product is for domestic use only.
If the product is damaged or has any defects, please contact cs[email protected].

1) Start by grabbing two (A) Poles and slidding the
Canvas (G) over the two poles. Then place four (D)at
each end of the two poles as shown in the image
above. To finish step 1 grab two (B) poles and place
join them together with the two A poles you already
have so that it looks like the image above. Complete
this process 4 times.
2) To make the draw place 1 base (H) in the inside of the draw (H) this gives the draw sturdyness and stability.
Repeat this process 4 times.
Part Name
Image
Quantity
A
10
B
10
C
16
D
20
E
4
F
1
G
5
H
4
USER MANUAL Model No:
USER MANUAL Model No: 4476
Assembly Instructions
Parts List:
If you are missing any of the below parts please contact
[email protected]
Please be aware that you will be referring to this parts list throughout the assembly
process.

3) Attach each base to each other by using poles (C) and placing
them into the holes at the top and bottom of Part (D). to
complete this step attach part (F) to the top of the stand. Please
see image to the right.
Please retain a copy of all instructions for future
consultation.
Imported into the EU by Oypla.com LLP, Uxbridge, UB8 2FX
USER MANUAL Model No: 4476
4) Complete the assembly of the unit by placing a draw into each
section as shown in the image to the left.