OYPLA Home 3731 User manual

10 Tier Shoe Cabinet
User Manual
USER MANUAL Model No: 3731

•This product is not a toy and should only be used for its designated purpose.
•Make sure that all platforms are secure before applying any weight to the product.
•This product is intended for indoor use only.
•Do not carry out alterations or modifications to this product.
•Do not discard any of the packaging until you have checked that you have all the
parts and fittings required.
•When placing shoes in the 10 Tier Shoe Cabinet, ensure that there are no sharp edges
or rough edges that will cause the canvas platforms to become torn and broken.
•Overloading the platforms can result in product failure or damage.
•Clean only with a damp cloth. Do not use strong industrial cleaning substances or
abrasive materials as these will damage the product.
•If the product is damaged or has any defects, please contact [email protected]
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.
Please retain a copy of all instructions for future consultation.
USER MANUAL Model No: 3731

Parts List:
If you are missing any of the below parts please contact [email protected]m
Please be aware that you will be referring to this parts list throughout the assembly process.
Operating Instructions
USER MANUAL Model No: 3731

USER MANUAL Model No: 3731
1. Take an end pole (part 3) and attach a connector
(part 2) to both sides of the end pole (part 3). Make
sure the connectors (part 2) are pushed against the
end pole (part 3) as far as they will go. Please see
the image to the left.
2. Push a side pole (part 4) into the other horizontal section of the connector (part 2). Repeat this on the opposite side
with another side pole (part 4). Once done, slide a canvas platform (part 1) down the side poles (part 4), ensuring that
the canvas platform (part 1) leaves space. Please see the image to the top left. After this, repeat step one and attach
it to the exposed ends of the side poles (part 4). Please see the image to the top right.
3. Push an end pole (part 3) into each of the vertical
sections of the connectors (part 2), ensuring that they
go as far down as possible. Once done, repeat the
first two steps to create another platform that you
can place on top of the vertical end poles (part 3).
4. Continue building upwards, repeating the
same building instructions in the steps seen
above until all the parts have been used. Once
done, remove the bottom platform and attach
the bottom of the cover (part 5) to the exposed
vertical end poles (part 3). Once done, pull the
cover (part 5) over the top platform, ensuring
that the cover (part 5) secured over both
corners. Be sure to not cause the cover (part 5)
to become too tight as this will allow for it to
become damaged easier due to the tension.