Oypla Kids 4217 User manual

Kid’s Wheelbarrow
User Manual
USER MANUAL Model No: 4217

Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.
USER MANUAL Model No: 4217
•Make sure all fastenings are tightly in place and that everything is in order before
using the product. This should be checked periodically by an adult.
•Unpacking, installing and fixing the parts are to be completed by an adult.
•Remove any packaging before giving toy to child.
•Do not carry out alterations or modifications to this product.
•Children should be supervised at all times when using the product.
•Clean only with a damp cloth. Do not use strong industrial cleaning substances.
•Leaving the product outside exposed to weather, especially direct sun and rain,
will speed the weathering process. This can be slowed by removing the product
from these conditions.
•Never exceed the maximum load capacity of 5kg, or it may result in product
failure and/or personal injury.
•Only use this product on stable ground.
•Do not discard any of the packaging until you have checked that you have all of
the parts and fitting required.
•This product is not suitable for children under the age of 3.
•If the product is damaged or has any defects, please contact [e-mail]

USER MANUAL Model No: 4217
Assembly Instructions
Parts List:
Please check you have all parts below before attempting to assemble this product.
If you are missing any of the below parts, please contact Oypla customer services:
[email protected]om

USER MANUAL Model No: 4217
1. Grab the barrow tub (H) and attach it onto the support bars (I,
J) using four bolts (A). To secure this, place four screw caps (B)
over the end of the screws.
2. Grab the wheel (G) and place the plastic tube (K)
through the middle hole in the wheel. Place one
stopping cap (D) on either side of the plastic tube (K).
Place a washer (F) on one side and follow this with a
screw (C).
3. Secure the screw (C) using one nut (E). Tighten this to
secure the product together alongside all other nuts.
Make sure to not over tighten the nuts.
Please retain a copy of all instructions for future
consultation.
Imported into the EU by Oypla.com LLP, Uxbridge, UB8 2FX