P. Graham Dunn POPPK1 User manual

INSTRUCTIONS: POPPK1
Floor Display
Includes:
A. Spinner Base (1)
B. Side 1 (2)
C. Side 2 (2)
D. Shelves (26)
E. Acrylic Inserts (26)
F. Shelf Dividers (26)
G. Marketing Sign (2)
H. Topper (1)
I. Bolts (4)
J. Cross Dowels (4)
K. Allen Wrench (1)
Notes:
-Two-person assembly
H
F
Acrylic Inserts
Marketing Sign
Shelves
Shelf Dividers
Spinner Base Side 1 Side 2
Topper
BC
F
H
Cross Dowels
Bolts
G
E
D
A
16.5”W x 72.75”H x 16.5”D
J
I
Allen
Wrench
K

1. Interlock Side 1 (B) and Side 2 (C)
together. Make sure the shelf slots are
facing inside. Repeat for the other set,
then connect all four sides together.
2. Place Topper (H) by aligning groove with
all four sides and sliding down. Insert two
Cross Dowels (J) into the circular
openings at the top of Side 2 (C). Assure
the slits in the Cross Dowels (J) are
vertical, using a Flat Head Screwdriver.
3. Screw one Bolt (I) through Topper (H)
and into Side 2 (C). Repeat for second
Bolt (I) on opposite Side 2 (C).
4. Flip the entire display upside down. Place
Spinner Base (A) by aligning groove with
all four sides and sliding down. Insert two
Cross Dowels (J) into the circular
openings at the top of Side 1 (B). Assure
the slits in the Cross Dowels (J) are
vertical, using a Flat Head Screwdriver.
5. Rotate Spinner Base (A) to align pre-
drilled holes. Screw one Bolt (I) through
hole in Spinner Base (A) and into Side 2
(C). Repeat for second Bolt (I) on
opposite Side 2 (C).
1
2
11
Note: If assembled correctly, Bolts (I)
will interlock with Cross Dowels (J) for
stability.
23
Note: Flipping the display will require
two people.
4
5
4
5
Note: If assembled correctly, Bolts (I)
will interlock with Cross Dowels (J) for
stability.

6. Flip the entire display right-side up.
7. Slide Shelves (D) into grooves at
bottom of tabs on sides. Then place
Shelf Dividers (F) into the aligning
slots on sides and Shelves (D).
8. Peel off white film from both sides of
Acrylic Inserts (E). Insert Acrylic
Inserts (E) into the vertical grooves at
the front of the tabs on sides (to
create a pocket).
9. Remove film from double-sided tape
on back of Marketing Sign (G). Place
at top of display, centered on Side 2
(C). Repeat for second Marketing Sign
(G) on opposite Side 2 (C).
10. Congratulations! Display is ready to
load with product.
Note: Flipping the display will require
two people.
77
8
10
8
9 9

Note: To place backer cards, begin by
folding along scored lines. Once
folded, place on shelf with category
name facing forward.

POPPK1-FDC1
Keepsake Cards