P. Graham Dunn POPSF6 User manual

Includes:
A. Spinner Base (1)
B. Center Panel (1)
C. Cross Dowels (6)
D. Bolts (6)
E. Allen Wrench (1)
F. Side Panels (2)
G. Shelf (12)
H. Topper (1)
I. Backplate (12)
Notes:
-Two person assembly
-Suggested Tools: Flat Head screwdriver
INSTRUCTIONS: POPSF6
Tabletop Shelf Display
C
A
Spinner Base
B
Center Panel
16”W x 26.5”H
D
Side Panels
F
Cross Dowels
C
Bolts
D
E
Allen Wrench
I
H
Topper
Backplate
I
G
Shelf

1. Stand Center Panel (B) upside down on
floor, with slots facing up. Insert Cross
Dowels (C) into each circular opening in
the Center Panel (B). Assure the slits in
the Cross Dowels (C) are parallel with
the Center Panel (B) openings, using a
Flat Head Screwdriver.
2. Place Side Panel (F) upside down and
slide into Center Panel (B) by aligning
slots in Side Panel (F) with tabs on
Center Panel (B). From the side, place
Bolts (D) in pre-drilled holes, then use
Allen Wrench (E) to tighten. Repeat for
second Side Panel (F).
3. Place Spinner Base (A), painted side
down, on top of Side Panels (F) by
aligning slots.
4. Rotate bottom of Spinner Base (A) until
pre-drilled holes are accessible. Place
Bolts (D) in pre-drilled holes, then use
Allen Wrench (E) to tighten.
4
4
1
2 2
3
4
1
3
Note: If assembled correctly, Bolts (D) will
interlock with Cross Dowels (C) for stability.
Note: If assembled correctly, Bolts (D) will
interlock with Cross Dowels (C) for stability.

5. Carefully grab the base and sides to flip
the display right-side up. Slide Shelves
(G) into corresponding slots on the
Side Panels (F).
6. Place the Topper (I) on top of display
by aligning slots with Center Panel (B)
and Side Panels (F).
7. Place Backplate (I) at the back of each
Shelf (G) to display product at an
angle.
8. Congratulations! Display is ready to
load with product.
8
1
7
5
Note: This should go on easily if lined
up properly.
Note: Flipping the display may require
two people.
5
7
5
7
6
8
7

Tabletop Décor
POPSF6-VBB1
POPSF6-SBB1
POPSF6-SBB2
POPSF6-SPS1
POPSF6-SPS2
POPSF6-HOU1
POPSF6-HOU2