
1. Stand Center Panel (B) upside down on
floor, with slots facing up. Insert Cross
Dowels (C) into each circular opening in
the Center Panel (B). Assure the slits in
the Cross Dowels (C) are parallel with
the Center Panel (B) openings, using a
Flat Head Screwdriver.
2. Place Side Panel (F) upside down and
slide into Center Panel (B) by aligning
slots in Side Panel (F) with tabs on
Center Panel (B). From the side, place
Bolts (D) in pre-drilled holes, then use
Allen Wrench (E) to tighten. Repeat for
second Side Panel (F).
3. Place Spinner Base (A), painted side
down, on top of Side Panels (F) by
aligning slots.
4. Rotate bottom of Spinner Base (A) until
pre-drilled holes are accessible. Place
Bolts (D) in pre-drilled holes, then use
Allen Wrench (E) to tighten.
4
4
1
2
3
4
1
3
Note: If assembled correctly, Bolts (D) will
interlock with Cross Dowels (C) for stability.
Note: If assembled correctly, Bolts (D) will
interlock with Cross Dowels (C) for stability.
2
4