Panasonic KX-TG7180E User manual

PQQW15294ZA DC0806PM0
Digital Cordless Answering System
Model No. KX-TG7160E
KX-TG7180E
1Connections
2Battery installation/
Battery charge (Initial charge: 7 hours)
Note:
LUse only the included rechargeable batteries.
Quick Guide
(220–240 V, 50 Hz)
To telephone network
Hook
Use only the included AC adaptor
and telephone line cord.
The pictured model is KX-TG7160.
Charge
contact
TG7160_7180E(e)_QG.fm Page 1 Thursday, July 27, 2006 12:08 PM

–2 –
3Bone conduction earpiece (KX-TG7180 only)
Note:
LThe effectiveness of the bone conduction earpiece will vary by the type and degree of
hearing loss of the user.
4Symbols used in these operating instructions
Date and time
1{j/OK}
2Press {^} or {V} to select “Handset Setup”. i{>}
3Press {^} or {V} to select “Time Settings”. i{>}
4Press {^} or {V} to select “Set Date & Time”. i{>}
5Enter the current day, month, and year.
6Enter the current hour and minute.
7{j/OK}i{ih}
5Accessibility
Caller ID announce
When you receive an outside call which has phone number information, the handset
announces the displayed phone number from the handset speaker.
LTo announce outside caller’s phone number, you must first subscribe to Caller ID service.
Consult your service provider/telephone company for details.
List announce
The handset announces phone numbers from the handset speaker while you are viewing the
redial list, caller list, and phonebook.
The handset features a
bone conduction
earpiece that uses
vibrations to create
sound during your
telephone
conversations.
Place the bone conduction
earpiece against your face
(not your ear).
Try different locations to
find which location works
best. Start with the temple
area.
Symbol Meaning
{j/OK}Press {j/OK}.
iProceed to the next operation.
“ ” Select the words in quotations shown on the display (e.g., “Handset
Setup”) by pressing {^} or {V}.
Bone conduction
earpiece
TG7160_7180E(e)_QG.fm Page 2 Thursday, July 27, 2006 12:08 PM

–3 –
6Basic operations
Answering system
Feature Operation
Making a call Dial the phone number. i{C}/{s}
Answering a call {C}
Hanging up {ih}
Receiver/speaker volume Press {^} or {V} while on a call.
Last number redial {R} i{C}
Making a call with redial list {R} iPress {^} or {V} to select the desired
number. i{C}
Handset phonebook: storing an
entry (name and phone
numbers)
{k} i{j/OK}i“New Entry” i{>}i
Enter the party’s name (16 characters max.). i
{j/OK}iEnter the party’s phone number (24 digits
max.). i{j/OK}i“Save” i{>}i{ih}
LTo enter a name, see the character table in the
operating instructions.
Handset phonebook: making a
call
{k} iPress {^} or {V} to display the desired entry.
i{C}
Handset ringer volume {j/OK}i“Handset Setup” i{>}i
“Ringer Setup” i{>}i“Ringer Volume” i
{>}iPress {^} or {V} to select the desired volume.
i{>}i{ih}
Changing ringtone
(outside calls)
{j/OK}i“Handset Setup” i{>}i
“Ringer Setup” i{>}i“Ext. Ringtone” i
{>}iSelect the desired ringtone. i{>}i
{ih}
Feature Operation
Answering on/off {j/OK}i“Answer System” i{>}i
“Answer On” or “Answer Off” i{>}i{ih}
Listening to messages {j/OK}i“Answer System” i{>}i“Play
New Msg.” or “Play All Msg.” i{>}
TG7160_7180E(e)_QG.fm Page 3 Thursday, July 27, 2006 12:08 PM

–4 –
7Frequently asked questions
Question Cause & solution
What kind of power outlet
should I connect the AC
adaptor to?
LConnect the AC adaptor to a 220–240 V outlet.
Why is wflashing? LThe handset is too far from the base unit. Move closer.
LThe AC adaptor is not connected. Check the
connections.
LYou are using the handset or base unit in an area with
high electrical interference. Place the handset and base
unit away from interference sources, such as antennas
and mobile phones.
LThe handset is not registered to the base unit. Register it.
{j/OK}i“Handset Setup” i{>}i
“Registration” i{>}i“Register H.set” i
{>}iPress and hold {x} on the base unit for about 3
seconds, until the registration tone sounds. iWait until
“Enter Base PIN” is displayed. iEnter the base unit
PIN (default: “0000”). i{j/OK}
Why is the handset display
blank?
LThe handset is not turned on. To turn the power on, press
{ih} for about 1 second.
What should I do when the
handset does not turn on?
LMake sure that the batteries are installed correctly.
LFully charge the batteries.
LClean the charge contacts and charge again.
How long should I charge new
batteries?
LCharge the batteries for about 7 hours.
How long is the battery
operating time?
LWhen you are using fully-charged Ni-MH batteries
(included batteries) ;
In continuous use: 12 hours max. (KX-TG7160)/10 hours
max. (KX-TG7180)
In continuous standby mode: 150 hours max.
– It is normal for batteries not to reach full capacity at the
initial charge. Maximum battery performance is
reached after a few complete cycles of charge/
discharge (use).
– Actual battery performance depends on a combination
of how often the handset is in use and how often it is
not in use (standby).
Can I keep the handset on the
base unit or charger when I
am not using it?
LEven after the handset is fully charged, the handset can
be left on the base unit or charger without any ill effect on
the batteries.
TG7160_7180E(e)_QG.fm Page 4 Thursday, July 27, 2006 12:08 PM

–5 –
8Optional service (Caller ID)
If you subscribe to Caller ID service, you can:
9Sales and support information
.
When should I replace the
batteries?
LIf the batteries are fully charged until 1is displayed,
but 3is displayed after a few calls, replace the
batteries with new ones.
What is a PIN? LThe PIN is a 4-digit number that must be entered in order
to change certain base unit settings. The default PIN is
“0000”.
What do I need to do to
display caller information?
LYou need to subscribe to Caller ID service. Consult your
service provider/telephone company for details.
LThe message “You must first subscribe to
Caller ID.” will be displayed until you receive caller
information after subscribing to Caller ID service.
– display caller information
– announce the caller’s phone number (Caller ID announce)
Customer Care Helpline Tel. No.: U.K. 08700 100 076 / R.O.I. 01289 8333
Question Cause & solution
Tom
012345
Customer Care Centre
LFor customers within the UK: 08700 100 076
LFor customers within the Republic of Ireland: 01289 8333
LVisit our website for product information: www.panasonic.co.uk
LE-mail: [e-mail]
Direct Sales at Panasonic UK
LOrder accessory and consumable items for your product with ease and confidence by
phoning our Customer Care Centre Monday - Thursday 9:00am - 5:30pm, Friday 9:30am
- 5:30pm (Excluding public holidays).
L Or go on line through our Internet Accessory ordering application at www.panasonic.co.uk
L Most major credit and debit cards accepted.
L All enquiries transactions and distribution facilities are provided directly by Panasonic UK Ltd.
L It couldn t be simpler!
L Also available through our Internet is direct shopping for a wide range of finished products,
take a browse on our website for further details.
TG7160_7180E(e)_QG.fm Page 5 Thursday, July 27, 2006 12:08 PM

IMPORTANT
If you have problems setting up or operating this product please call
the Panasonic DECT Helpline
08700 100 076 (UK)
01289 8333 (Repl of Ireland)
TG7160_7180E(e)_QG.fm Page 6 Thursday, July 27, 2006 12:08 PM