
7
Safety Precautions
WARNING
Setup
Do not place the Display on sloped or unstable
surfaces, and ensure that the Display does not hang
over the edge of the base.
The Display may fall off or tip over.
Do not place any objects on top of the Display.
Do not cover the ventilation holes.
Transport only in upright position!
internal circuitry.
Leave a space of 3 15/16” (10 cm) or more at the top,
left and right, and 1 31/32” (5 cm) or more at the rear,
and also keep the space between the bottom of the
Cautions for Wall Installation
professional. Installing the Display incorrectly may
lead to an accident that results in death or serious
Caution for Ceiling Suspension
installation professional. Installing the Display
incorrectly may lead to an accident that results in
death or serious injury.
An apparatus with CLASS I construction shall be
connected to a mains socket outlet with a protective
earthing connection.
Do not install the product to a place where the
If the screen is exposed to direct sunlight, the liquid
crystal panel may have adverse effect.
AC Power Supply Cord
The Display is designed to operate on 110 - 127 V AC,
50/60 Hz.
Ensure that the mains plug is easily accessible.
Do not use any power supply cord other than that
provided with this unit.
Securely insert the power cord plug as far as it will go.
Do not handle the power cord plug with wet hands.
Doing so may cause electric shocks.
Do not do anything that might damage the power
cable. When disconnecting the power cable, hold the
plug, not the cable.
If the Display will not be used for a long period of
time, unplug the power cord from the wall outlet.
If problems occur during use
If a problem occurs (such as no picture or no sound),
or if smoke or an abnormal odor is detected from the
Display, unplug the power cord immediately.
Continuous use of the Display under these conditions
personnel are strongly discouraged due to its high
voltage dangerous nature.
If water or foreign objects get inside the Display, if
the Display is dropped, or if the cabinet becomes
damaged, disconnect the power cord plug
immediately.
Maintenance
The front of the Display panel has been specially treated. Wipe the panel surface gently using only a cleaning
cloth or a soft, lint-free cloth.
the surface is dry.
If the cabinet becomes dirty, wipe it with a soft, dry cloth.
Usage of a chemical cloth
Do not use a chemical cloth for the panel surface.