Panasonic AW-HS50 Series User manual

★ This is to explain the procedure for combining a sub screen image with the background image.
(Procedure for selecting the PinP signal)
① Press PinP button – (Fig.1-A to set the crosspoint buttons to PinP material selection mode (PinP button blinks .
② Using the B bus buttons, select the PinP signal. – (Fig.1-B
③ Press PinP button to release the PinP material selection mode(PinP button goes off .
④ Press PinP ON button – (Fig.1-E to combine the PinP image.
(PinP settings)
Changing the shape, position and size of the PinP image to be combined is enabled as well as adding the border effect to
it.
⑤ Hold down the OSD ON button – (Fig.1-C for 2 seconds to open the menu. (To close it, hold down the button again
for 2 seconds.
⑥ Use the OSD/TIME dial – (Fig.1-D to set or adjust the settings for the menu items in [3] PinP Menu. – (Fig.2 & Fig.3
＝
＋
Combining PinP (Picture in Picture)
(Figure 1: AW-HS50 Control Panel
（A）
（B）
（C）
（D）
（E）
Background PinP Signal Output Image
(Figure 2: AW-HS50 Menu Display Screen

* For the details, please see pp. 18 – 19 of Operating Instructions <Operations and Settings>.
(Figure 3: AW-HS50 Menu Display Screen
1. Setting for shape of PinP image to be combined
2. Adjustment of center position and size of
PinP image
X coordinate (X , Y coordinate (Y , size (S
4. Setting for the width of PinP image border (B
* Set “0.0” when the border effect is not to be added
Setting for the amount of soft effect on PinP image (S
5. Setting for the color of PinP image border
6. Adjustment of hue (H , saturation (S and
luminance (L of color that has been set
for border