Panduit NET-ACCESS S2RP User manual

INSTRUCTIONS V00029DP
© Panduit Corp. 2014
FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp
N ET -A CCESS S-Type Server Cabinets
(S2RP, S5RP, S8RP, Adjustable Cage Nut Equipment Rails )
Equipment Rail
Mounting Bracket
Equipment Rail Installation
• Install [4] Equipment Rail Mounting Brackets to Equipment Rails with [3] Counter-sunk Torx screws per bracket (use T25 Torx bit)
• Ensure that counter-sinks of brackets are oriented to match heads of counter-sunk screws
Page 1 of 2
[3] Counter-sunk Torx Screws
(use T25 Torx bit)
Ensure that counter-sinks
of bracket match screw
Insert Patching Adapters
(snap into equipment rails)

For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
E-mail:
[email protected]
Phone:
866-405-6654
www.panduit.com
INSTRUCTIONS V00029DP
M10 Hex Head Screw
(use 15mm socket wrench)
M10 Hex Head Screw
(use 15mm socket wrench)
INSTALL EQUIPMENT RAILS
M10 Hex Head Screw
(use 15mm socket wrench)
Equipment Rail
Mount Nut
Slot of Front-to-Back Beam
Equipment Rail
Mount Nut
(Finger Grip Area)
Barbed Surface
(face to outside
of cabinet)
Equipment Rail Installation
• Locate desired Equipment Rail position
• Insert [2] Equipment Rail Mount Nuts through slots of Front-to-Back Beam (top and bottom locations)
• Fasten [2] M10 Hex Screws to E-Rail Mount Nuts at top and bottom of Equipment Rail
• Tighten M10 Hex Head Screw to 30.0 +/- 5.0 N-m [22.1 +/- 3.7 Ft-lbs]
Page 2 of 2