Panduit NREPB1 User manual

FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp
INSTRUCTIONS CM406D
© Panduit Corp. 2017
Page 1 of 2
NETRUNNER End Panels
Part Numbers: WMPV45EPB1, NREPB1
WMPV45EPB1
(2) End Panels
(4).375-16 Acorn nuts
(4).375 -16 Bolts
Assembly:
Step 1:
Insert bolt into mounting
location one.
Step2:
Place End Panel over the
bolt and hand tighten nut.
Step 3:
Insert bolt into location two
a secure with acorn nut.
Tighten acorn nut in loca-
tion one.
Mounting Locations
Geometry modified for clarification: Not
all molded fingers are shown
Step 4:
Repeat steps 1-3 for upper
End Panel End Panel
WMPV45EPB1 (Shown)
Note: Install lower end panel first when
using a stacked configuration.
WMPV45EPB1 Installation Instructions
Mounting Location 1
Mounting Location 2
Mounting Location 1
Mounting Location 2

INSTRUCTIONS CM406D
For instuctions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
E-mail:
[email protected]
Fax:
[phone]
www.panduit.com
Page 2 of 2
NREPB1
(2) End Panels
(4) 3/8-16 Acorn Nuts
(4) 3/8 Bolts
(2) 1/4” Washers
(2) 1/4-20 X 3/8” Screws
(2) 1/4-20 Nuts
Knockouts to
be removed
NREPB1 Installation Instructions
Note: Install lower end panel first when using a stacked configuration.
3/8-16 Nuts
Installation to right
side of rack
3/8-16 Bolts
3/8-16 Bolt
3/8-16 Nuts
tighten by hand
1/4-20 Bolts and
Washers
1/4-20 Nuts
Bracket may be anchored to floor using these slots
(Hardware not included). Bracket may be orientated
on either inside or outside of panel. Note: Bracket
must be mounted outward when Cool Boot is used.
Bracket holes are orientated
on bottom of bottom panel.
Determine knockouts to be removed by lining up panel against manager.
Close up of bolt
Bracket Holes
Installation to left
side of rack
Bracket holes are orientated
on top of top panel.
mounting locations
Knockouts to be
removed
3/8-16 Nuts
3/8-16 Nuts
tighten by hand
tighten by hand
tighten by hand