HD88-EI00 05/2018 paradox.com
HD88
720P HD Outdoor Camera
Installation Manual
**Compatible with Insite
GOLD and SWAN Server**
Introduction
The HD88 is an outdoor 720P HD camera with built-in sound, pet
immune security motion detector, with Ethernet and WiFi. It provides
up to 30 minutes of internal Recording on Trigger memory space, or
16GB to 256Gb SD card that can be added for additional recording
space.
Installing the HD88
Bracket Installation
If wall bracket tamper is connected, tamper will automatically be
detected by the camera. Tamper will follow recognition settings set in
the panel.
HD88 Bus / Ethernet Wiring
Wire the HD88 camera with a CAT5e or higher cable. Connect the two
twisted pairs to the Green (Data) and Clock (Y) of the panel bus and two
twisted pairs for the Ethernet lines. The maximum CAT5e cable length is
50 meters. When using Ethernet do NOT use Green (Data) and Yellow
(Clock) in one twisted pair, but rather separate them into different twisted
pairs as shown below.
Use a separate minimum 18 gauge wire for the power. If your power is
not coming from the panel or a bus power supply then you will also need
to connect the solid blue of the CAT5e cable to the negative (-) of the
camera to have a common ground.
HD88 WiFi Wiring
Wire the HD88 camera with a standard 4-wire bus cable. Connect the
Yellow and Green to the Green (Data) and Yellow (Clock) of the panel
bus.
Use a separate 18 gauge (minimum) wire for the power. If your power is
not coming from the panel or a bus power supply then you will also need
to connect the Black of the 4-wire bus cable to the negative (-) of the
camera to have a common ground.
HD88 Wiring Table
Registration LED Status Indicators
SD Card Installation
An SD card can be inserted into the HD88 in order to provide
additional recording time. Please note that if using Record On
Trigger, an SD card must be inserted into the camera as shown.
LED Status Indicators
Other than PIR detection, LEDs are active when lock mechanism is
open.
Recommended Wire
Assignment Ethernet Connector
Bus Label Wire Color Ethernet
Connector Wire Color
RX- Orange 1 Green
striped
RX+ Orange striped 2 Green
TX- Green 3 Orange
striped
TX+ Green striped 4
YBrownstriped5
G Blue striped 6 Orange
B- Black (18 AWG) 7
R+ Red (18 AWG) 8
WiFi Wire Assignment Bracket Wire Assignment
4-Wire Bus
Label Wire Color Bus Label Wire Color
Y Yellow TMP Blue
G Green B- Black
B- Black (18 AWG)
R+ Red (18 AWG)
Network Status LED Functionality
HD88 is not connected to a local
WiFi network
LED and LED will flash
intermittently
HD88 is connected to a local
network but failed to poll the
SWAN Server
LED is set to On
and LED is Flashing
HD88 is connected to a local
network and succeeded in
polling the SWAN Server
LED is set to On
and LED is set to On
LED Functionality LED Display
TX Digiplex/Spectra Data TX
Flashing green: Data
transmission
Off: No data
transmission
RX Digiplex/Spectra Data RX
Flashing green: Data
reception
Off: No data reception
Firmware upgrade in
progress. Flashing purple
VOD* Blue on
Power-up Flashing blue
Locate mode Flashing blue
No connection to panel bus Flashing red
Bus low power Flashing red
PIR detection Red on for 3 seconds
Active Wi-Fi Green on
LAN 10/100Mb link Green on: LAN active