Parker House Sierra DSIE DRC-MRMS User manual

Sierra Dining Chair
Sierra Dining Chair
Description :
Caution:
Dimension : 22 1/2"W×29 1/2"D×41"H
Please retighten all connections periodically
Please inspect all connections periodically and retighten them if loose.
1
ASSEMBLY INSTRUCTIONS
Build
Simply

2
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have the
following parts:
IMPORTANT NOTE:
Thank you for purchasing this quality product. This product has been designed for easy assembly and constructed for durability. Please take
the time to read and follow the assembly instructions carefully.
Be sure to check all packing material carefully for small parts which may have come loose inside the carton during shipment. Please separate,
identify, and count all parts and metal hardware. Compare with part list to be sure all parts are present.
Remove all wrapping material, including staples & packing straps before you start to assemble.
DO NOT tighten all screws and bolts until completely assembled.
Keep all hardware parts out of reach of children.
Unzip cushion seat bottom to remove parts carefully.
BEFORE ASSEMBLY
PART LIST
Part DrawingQtyDescription Part DrawingQtyDescription
B1
Back Leg (L)
C1
Back Leg (R)
D1 Chair Body
A2Front Leg H2 8
Flat WasherH3 8
Spring Washer
T1 1Allen Wrench
H5 4Foot leveler
H1 8
Bolt
(M8x60mm)

3
Please lay the Chair Body (D) on soft, clean surface to assemble.
Open the dust cover and take out the parts package from the bottom of seat.
STEP 1
D
Bottom of Seat
B x 1
A x 2
C x 1
H1 x 8
H2 x 8
H3 x 8
H5 x 4
T1 x 1
dust cover
Insert the Front Legs (Ax2) and Back Legs (B&C) into the corresponding four slots on the bottom of
the Chair Body (D). Attach them with Bolts (H1x8),Spring Washers (H2x8), Flat Washers (H3x8) and
Allen Wrench (T1).
Note: Do not fully tighten yet.
STEP 2
H3
H2
H2
H1
H1
T1
H3
H3
H2
H2
H1
H1
H3
x2
x2
T1
B
(R) (L)
C
D
AA
A
B / C
dust cover
NOTE:
We defined the left and right of wooden legs
when facing this product upright.

Congratulations! We hope you enjoy your purchase.
Foot levelers
B
A
A
STEP 4
Flip the chair over and press down on seat over legs to secure in place.
Tighten each Foot Leveler (H5) to each wooden leg.
Adjust the balance of the chair again with foot levelers if needed. Assembly complete.
4
STEP 3
Tighten all bolts and close the dust cover.
Fully tighten all bolts.
x8
T1 dust cover
Reclose the dust cover.
H5x4