Patriot Docks 10832 User manual

Patriot Docks
Bench Kit Assembly Instrucons
PN 10832, 10833, 10837, 10936
Required Tools: Phillips driver, 14mm and 17mm
wrench and/or socket
Parts List:
(2) Aluminum Uprights
(2) Aluminum Bench Supports
Aluminum, Cedar or Poly Bench covering
(2) 11” Adhesive Insulator
Hardware:
(8) M10x100mm Bolts/Nut
(4) M10x70 Bolts/Nut (Truss Frame Mounng)
(2) M10x90 Bolts/Nut (Low-Pro Mounng)
(12)#6 x 1-1/2” Phillips head Screws
(Cedar and Poly Only)
Step 1: Aach 11” Adhesive Insulator on the
boom of Bench Upright, where the Upright
Frame will make contact with Decking. See
Fig. 1.
Step 2:
The Bench Kit is made to directly mount on
the 4’ end of any Patriot Dock Truss Frame
(PN10800) Fig.2. If using on the 8’ Side Rail
some drilling may be required. With decking
in place aach upright to the Patriot Dock
Frame using (4) M10x70mm Bolt/nuts. When
mounng onto Patriot Docks Low-Pro Frame
(PN10835) Fig.3, mount to 8’ side rail using (2)
M10x90mm Bolt/nut included.
Truss Frame Mounng
Low-Pro Mounng
Fig. 1
Fig. 2 Fig. 3

Step 2:
Aach cedar or poly boards to the Aluminum Bench Supports using six 1-1/2” long phillips head
screws. Maintain a half inch space between cedar boards and 1 1-1/2” space from the end of
the boards as pictured below (Fig. 4). When aaching poly boards, align the holes in the Alumi-
num Bench Supports with the pre-drilled holes in the poly board. Secure using six 1-1/2” long
phillips head screws. (Fig. 5) and (Fig. 6)
Step 3:
Aer decking has been aached to the Aluminum Bench Supports using phillips head screws,
the Aluminum Bench Supports can be set in place and aached to the Aluminum Uprights us-
ing the M10 x 100mm bolts, nuts and washers. See (Fig. 6).
Step 4:
Aluminum Dock-Top bench only: Install plasc End
Caps into the ends of the aluminum deck boards.
Gently tap End Caps into place using a mallet
Fig. 5
Fig. 4 Fig. 6