Patron D-160 User manual

D-160 DEHUMIDIFIER
INSTRUCTION MANUAL
Please keep this manual for further reference

4
OPERATION
Power Button: When the machine is in the standby mode, the
display screen will be displayed in low light LED. To start the
dehumidifier, press the power button. Concurrently, the display screen will
light up and the unit will run in Auto mode, the default humidity setting is
10%RH, and the machine will start if the ambient humidity is above the
setting.
Press the power button again to turn off the machine, and the fan will shut
down in 1 minute later.
Timing Button: Press the timing button ,the display screen
will show the current timing data, and then press Add Button
to increase the timing data or press Minus button to decrease the timing
data. Press one time to increase or decrease one hour . The timing indicator
will light up after setting. When the machine is in the standby mode, press the
timing button to set the start-up time; when the machine is running, press it to
set the shutdown time. The timing setting range is from 0 to 24 hours. If you

9
TROUBLESHOOTING GUIDE
Trouble Possible Cause Solution
Error Code: E1 Copper head sensor failure Replace it
Error Code: E2
Air inlet temperature and humidity
sensor failure
Replace
Error Code: E3
Air outlet temperature and humidity
sensor failure
Replace
Error Code: E4 Water pump failure
Ensure drain hose is not
blocked, and connected to
back of unit (unit will not
pump unless hose is
connected)
Ensure internal hose from
pump to fitting is not
restricted by clamp
Test/replace water pump
Error Code: E5 4-way valve failure Replace it
Cautions:
If unit malfunctions turn off the unit and unplug it immediately.
Please contact your distributor for service issues.
D
o not dispose of electrical appliances in local landfills, or
m
unicipal waste locations. Many parts are recyclable. Contact
y
our local government for information regarding the
collection systems available in your area.